CORNING Pretium Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Bastidores y soportes CORNING Pretium. CORNING Pretium 10 páginas. Rack-mountable 1u housing hardware

Imprimir página

3.9

Installing Closet Connector Housing Pigtail Modules

Step 1:

Remove the blank panels from the unit and replace with pigtail modules (purchased

separately).

Step 2:

If you intend to splice inside the PCH-01U unit using the Splice Tray Kit (p/n PC1-SPLC-

04R), remove the radius control guides and install the splice tray kit per the instructions

provided with it. Route cable slack around kit and into the splice trays. Splice per the

instructions provided with the splice tray (Figure 8).

Step 3:

If you intend to splice using an external splice housing, route slack around the radius

control guides and through the rear entry openings to the applicable splice housing above

or below the PCH-01U unit (Figure 9).

IMPORTANT:

STANDARD RECOMMENDED PROCEDURE 003-649 | ISSUE 5 | JANUARY 2009 | PAGE 7 OF 10

Lift the tray stop latches and slide the drawer to the forward and back positions to

verify that the drawer slides in the grooves of the guides and that there is enough

fiber slack to prevent violating the minimum fiber bend radius of the cable.

Cable Tie

KPA-1198

Figure 7 — Cable Slack Routing and Connector Installation

Cable Tie

Figure 8 — Install Splice Tray Kit

KPA-2227