Makita 6805BV Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita 6805BV. Makita 6805BV 12 páginas. Variable speed/reversing
También para Makita 6805BV: Manual de instrucciones (8 páginas)
Imprimir página
Adjusting fastening torque
When you wish to drive machine screws,
wood screws, hex bolts etc. with the pre-
determined torque, adjust the fastening
torque
as
follows.
The fastening torque may be adjusted by
turning the adjusting ring. Before turning
the adjusting ring, turn the locator in the
direction of the arrow as far as
it
will go
without forcing. The torque is increased
by turning the adjusting ring in the direc-
tion of the arrow and decreased by turn-
ing
it
in the opposite direction. Align the
I
number 1 on the adjusting ring with the pointer on the gear housing. Drive a trial screw
into your material or
a
piece of duplicate material. If the fastening torque
i s
not suitable
for the screw, continue adjusting until the proper torque
is
obtained.
CAUTION :
The adjusting ring should be turned only within the numbered range. It should not be
forced beyond this range.
Switch action
Tool speed is increased by increasing
pressure on the trigger. To start the tool,
simply pull the trigger. Release the trigger
to stop. For continuous operation, pull the
trigger and then push in the lock button.
To stop the tool from the locked position,
pull the trigger fully, then release it.
I
Trigger switch
Lock button
I
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to
the "OFF"
position when released.
NOTE :
Even with the switch on and motor running, the bit will not rotate until you fit the point
of
the bit in the screw head and apply forward pressure to engage the clutch.
6