Makita 7104L Información técnica - Página 5

Navegue en línea o descargue pdf Información técnica para Herramienta eléctrica Makita 7104L. Makita 7104L 8 páginas. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
También para Makita 7104L: Manual de piezas (4 páginas), Folleto (1 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (13 páginas)

Imprimir página

epair

When removing M14 Screw from the front vice section;

1) Press the end of M4 Screw against table to compress

Compression spring 10.

2) At the same time, push out 4-20 Spring pin in M14 Screw

using Spring pin extractor 4.0 (Makita part No. 1R308).

See Fig. 12.

[7] Adjustment

Note: The following information applies to the products including 16.5mm cutter chain as the standard accessory.

1) Fix an yellow colored Indication plate to Base complete with M4x8 pan head screw as shown in Fig. 13 after aligning

the front edge of the Indication plate with front end of 16.5mm cutter chain.

2) When aligning the center of + Countersunk head screw M6x12 with the bottom of Base complete, drive Stopper pole

into the Base complete by hand in order to adjust the height of Rotor holder at ZERO position on Stopper pole as

shown in Fig. 14. After positioning it, tighten M8 Hex. nut onto the hole of Base complete firmly using Wrench.

Note: Face the gauge of Stopper pole to outside before tihgtening M8 Hex. nut.

3) Align the left end of Scale plate with the left end of the cutter chain by resetting the scale plate on the Base complete.

See Fig. 15.

Fig. 13

Indication plate

Fig. 14

Center of + Countersunk

head screw M6x12

Hex. nut M8

Pan head screw M4x8

Bottom of Base

complete

Rotor holder

Threads of the

Stopper pole

Base complete

Fig. 12

Spring pin 4x20

M14 Screw

Slide Indication plate

backward or forward.

Front edge of Indication

plate (yellow)

Gauge of the Stopper

pole

Fig. 15

P 5 / 8

Spring pin extractor 4.0

Plastic hammer

Table

Front end of 16.5mm

cutter chain

"ZERO" mark

Left end of 16.5mm

cutter chain

Scale plate

Left end of Scale plate