Makita 903DW Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita 903DW. Makita 903DW 17 páginas. Cordless blade sharpener
Imprimir página
Installing or removing battery cartridge
0
Always switch off the tool before insertion or removal of the battery cartridge.
0
To remove the battery cartridge, pull out
the
set
plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the barrel.
0
To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the
s e t
plate fully before
using the tool.
I
Battery cartridge
I
0
Do
not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it i s not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sides
as
their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that
it
rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If the charging light does not come on, press the reset button (yellow) first, then the start
button (red). If the charging light goes out within 10 seconds even after pressing the reset
button and start button a couple of times, the battery cartridge
i s dead.
(CAUTION
:
Wait
for more than 5 seconds after the charging light goes out to press the reset button again.)
Replace
it
with
a
new one. When the charging light goes out after about one hour,
you
may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION
:
0
Your new battery cartridge is not charged. You will need to charge it before use.
0
Do not keep the button pressed in with tape, etc., or the circuit will not function pro-
perly. Also, a malfunction of the charger may result possibly causing overheating, etc.
0
If you try to charge
a
cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it
and try to charge
it
once more.
0
When you charge a new battery cartridge or
a
battery cartridge which has not been used
for a long period,
it
may not accept
a
full charge. This
i s a
normal condition and does
not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it
completely a couple of times.
0
If
you
wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
6