Makita DA4031 Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita DA4031. Makita DA4031 8 páginas. Angle drill
También para Makita DA4031: Desglose de piezas (3 páginas), Manual de instrucciones (17 páginas), Desglose de piezas (3 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (10 páginas)
Imprimir página
ENGLISH (Original instructions)
SPECIFICATIONS
Capacities
No load speed (min
Overall length (With an extended spade grip)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for drilling in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Model
Wood
Self-feed bit
Steel
-1
)
Net weight
Safety class
equipment
and
environmentally
compatible
DA4030
Auger bit
38 mm
65 mm
Hole saw
-----
13 mm
1,200
417 mm ( 491 mm)
5.5 kg
END201-5
For Model DA4031
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The
vibration
determined according to EN60745:
its
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE032-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENF002-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
DA4031
High
38 mm
65 mm
-----
13 mm
1,200
462 mm (536 mm)
6.3 kg
/II
) : 87 dB(A)
pA
) : 98 dB(A)
WA
Wear ear protection
total
value
(tri-axial
2
) : 2.5 m/s
h,D
2
Low
118 mm
152 mm
300
ENG102-2
ENG202-3
vector
sum)
or less
ENG901-1