ALIBI ALI-TS2128R Manual de instalación rápida - Página 2

Navegue en línea o descargue pdf Manual de instalación rápida para Cámara exterior ALIBI ALI-TS2128R. ALIBI ALI-TS2128R 5 páginas. 8mp tvi/ahd/cvi/cvbs varifocal 200 ft ir outdoor turret camera

Imprimir página

Anchor the mounting base to the ceiling with appropriate fasteners. If the camera drop cable will be

routed through a cable channel, make sure it is in place before securing the mounting plate to the

surface.

Cable channel (2)

Connect the camera drop cable to video and power extension cables.

Reattach the camera to the mounting plate.

Position the camera assembly onto the mounting plate such that the lip on the black ring

attached to the enclosure slips under the tabs on the mounting plate.

Mounting plate

Slide the clip plate out.

Mounting plate



Enclosure

 Push the enclosure into the mounting plate until it is fully seated.

x Slide the clip plate in so that it catches the lip of the black ring on the encloser.

y Tighten the clip plate screw until it is just snug.

Connect the far end of the video extension cable to a compatible digital video recorder (DVR).

10.

Connect the far end of the power extension cable to a power supply, then apply power to the

camera through the power extension cable.

11.

While observing video from the camera on a monitor, aim the camera at your surveillance target.

See the figure below for adjustment ranges.

Pan adjust

0° ~ 360°

Rotation

adjust

0° ~ 360°

www.observint.com

Cable channel

Tabs

Clip Plate

Tilt adjust

0° ~ 75°

NOTE

When adjusting the turret rotation, ensure that the "UP" label is positioned at the top.

Open the OSD menu

The On Screen Display (OSD) provides configuration options for refining the performance of the camera.

It also can be used to block sensitive portions in the field of view (Privacy). You can open the OSD menu

system from either an ALIBI recorder Live View display or through remote login to the ALIBI recorder.

− Opening the OSD Menu through the recorder

To open the OSD menu on the recorder monitor:

12.

Open the recorder Live View screen, and then click inside the screen where the PTZ camera video

image is displayed. See below.

Click the PTZ Control icon in the Quick Setting Toolbar. The PTZ camera Live View window will

13.

expand to full screen and the pop-up window shown below will open.

Menu icon

14.

In the PTZ Control panel pop-up window, click the Menu icon on the Configuration line.

15.

Drag the PTZ Control window to a position where it doesn't cover the OSD menu (such as the left

side).

The PTZ Control window direction buttons and the Iris + and Iris - keys are used to navigate the

OSD menu and set configuration options in the camera. See "OSD Definitions: On-screen Display

NOTE

(OSD) menus" on page 3.