Corsa 14249 Instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación para Campana de ventilación Corsa 14249. Corsa 14249 4 páginas. Cat-back exhaust system for chevrolet avalanche 2007; chevrolet avalanche 2008; chevrolet suburban 2007; chevrolet suburban 2008; gmc yukon xl 2008; gmc yukon xl 2007; chevrolet tahoe 2007; chevrolet tahoe 2008; gmt900 2008; gmt900 2007
Removal of Stock System:
1) Lower the spare tire by following the instructions in the owner's manual.
2) Remove the heat shield using a 15mm socket and ratchet. (See Fig's A, B & C)
3) Place a chain style cutter around the tailpipe at the tunnel muffler exit and cut the tailpipe
at this location. (See Fig. D)
4) Remove the grommets from the tailpipe hangers using grommet pullers or similar device.
(See Fig's E & F) NOTE: Using a soapy water solution on the grommet hole will make
the job easier.
5) Remove the tailpipe section from the vehicle by lifting the tailpipe over the rear axle and
backwards under the rear bumper. Be sure to move the rear differential vent hose out of the
way when performing this operation. (See Fig's G & H)
6) Use a 15mm socket and ratchet to remove
the flange nuts at the flange connection of
the head-pipe. Then remove the grommet at
the hanger location and remove the tunnel
muffler section away from the vehicle. This
completes the removal of the stock system.
(See Fig's I & J) NOTE: Using a soapy
water solution on the grommet hole will
make the job easier.
FIG. C
FIG. G
FIG. D
FIG. H
Exhaust System Installation: Cat-Back Exhaust System
2007-08 Avalanche/Suburban/Yukon XL 5.3L GMT900
Single Side Exit
Twin Pro-Series 4.0" Tips / SPORT PN 14246 / TOURING PN 14247
Hydroformed Oval Tip / SPORT PN 14248 / TOURING PN 14249
FIG. A
FIG. E
FIG. I
FIG. B
FIG. F
FIG. J