Avantone Pro CLA-200 Manual - Página 4
Navegue en línea o descargue pdf Manual para Amplificador Avantone Pro CLA-200. Avantone Pro CLA-200 8 páginas. Studio reference amplifier, class a/b 200 watts per channel, 500w mono
Imprimir página
The Avantone Pro CLA Studio Reference Amplifier is a classically designed
Class A/B amplifier. We took particular care to create an amplifier in the
traditional studio style, with generous VU meters, high quality Japanese
components and a serious toroidal transformer linear power supply. In a
standard 2U rack mount chassis, this amplifier can generate over 200 watts per
channel into an 8 ohm load, making it perfect for medium to large speakers in a
studio environment. The CLA200 is convection cooled – no fan noise, so it can
be used in the same room as the monitors.
The CLA200 Studio Reference Amplifier is designed to be used in a studio
environment requiring high power output with no fan noise. Under testing, it
delivers a powerful 208 watts into 8 ohms and can run at one third power
without thermal fault.
The CLA200 was designed to be paired with the CLA-10 studio monitors, but it
can be used with just about any demanding speaker load. Very low distortion,
steady performance under harsh conditions, and an open and transparent
sound make this an obvious choice for discerning studios.
ENGINEERING OBJECTIVES
The AVANTONE PRO CLA-200 Studio Reference Amplifier is a dynamic,
high output, high resolution, full-range system built the old school way. We
included no-compromise components in a 2U convection cooled chassis to
complement our CLA-10 Studio Reference Monitors. Of course, it can be used
with any passive studio monitor requiring serious dynamic range.
QUICK START GUIDE
•
Select the operating voltage. If you are changing voltages, please be
sure to change fuse values as specified on the rear panel
•
Select operating mode: either two independent channels or mono
bridged mode.
•
Place volume controls to minimum
•
Connect audio input, speaker cables and power cord with power switch
in OFF position
•
Plug power into AC source
•
Turn on all upstream equipment; run outputs at minimum
•
Turn on power switch
•
Adjust volume to appropriate level at source and speaker
•
Enjoy
REAR PANEL CONTROLS / CONNECTIONS
•
BALANCED INPUT: The XLR and phone plug inputs accept a BALANCED
male XLR plug as well as a 3-conductor BALANCED TRS ¼" or a 2
conductor UNBALANCED TS ¼" male plug. For unbalanced operation with
INTRODUCTION