JAMO STUDIO8 Series Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Subwoofer JAMO STUDIO8 Series. JAMO STUDIO8 Series 8 páginas.

CONNECTIONS AND CONTROLS

CAUTION: Ensure that the subwoofer is unplugged from the AC wall outlet before making

any connections.

"LINE IN" Connection - Most of today's surround receivers (and pre-amplifiers) have a line

level subwoofer output labeled Subwoofer Pre Out, Sub Out, SW Out, etc. If you have this

output, connect one end of a subwoofer cable to it and connect the other end of the cable

into the subwoofer line input labeled LEFT/LFE. This connection allows the subwoofer to

operate with both music and surround sound movies (refer to your receiver manual).

Level - If your subwoofer is connected to a Subwoofer Output of a surround receiver, first

set the subwoofer volume level control in the receiver to the "half way" or "0 dB" position.

Then increase the volume (or gain) of the subwoofer up until the subwoofer's volume level

matches the output of your main speakers. After this setup is completed, the volume control

on your system's main amplifier or pre-amplifier will be the volume control for both your

subwoofer and speakers together.

"LOWPASS" Control - The crossover point chosen determines where low bass frequencies

are "handed off" from the speakers to the subwoofer. If setting the crossover point in the

receiver, turn the Lowpass Filter knob on the subwoofer to the farthest point right (160Hz).

Set the crossover point based on the size of the main left/right speakers you are using in

the system. As a general rule, for larger, floorstanding speakers, set the crossover point

between 50Hz-90Hz. If using small bookshelf or "satellite" speakers for the mains, set the

crossover point between 90Hz-150Hz. The smaller the speaker, the higher the setting

until the bass frequencies blend well between the speakers and your subwoofer once your

system is completely hooked up. If your receiver does not have a crossover point setting, set

the Lowpass Filter on the subwoofer instead within the same recommended settings (see

receiver manual for additional speaker setup info).

"PHASE" 0/180 - This control is used to acoustically match the subwoofer's output to your

main speakers. Select the position, either 0° or 180°, in which your subwoofer has more

output at the listening position.

"POWER" AUTO/ON/OFF - When this switch is in the "AUTO" position, the subwoofer will

automatically turn "on" when it senses a signal. It will automatically go into "standby mode"

after 15-20 minutes with no signal. When this switch is in the "OFF" position, the subwoofer

will remain "off" until the switch is manually turned back to the "ON/AUTO" position.

Power LED indicator - Located on the front baffle, this LED indicates the operating status

of the built-in amplifier. The LED will light green when the amplifier is on and receiving

a signal. If the LED is dark and not lit, the amplifier is off. For more information on the

controls mentioned in this manual and on bass management, see your dealer or visit