KitchenAid YMER8850DS1 Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Gamas KitchenAid YMER8850DS1. KitchenAid YMER8850DS1 16 páginas. 30" (76.0 cm) freestanding electric ranges

Imprimir página

1. Table of Contents

On Ranges Equipped with a Storage Drawer:

Remove the storage drawer. See the "Storage Drawer"

section. Use a 1¼,, d rive ratchet to lower the rear leveling legs

one-half turn. Use a wrench or pliers to lower front leveling

legs one-half turn.

...."2

.........

y///'

A. ¼" drive ratchet

B. Rear levering leg

C. Wrench or pliers

D. Front leveling leg

On Ranges Equipped with a Warming Drawer or Premium

Storage Drawer:

On ranges equipped with a warming drawer or premium

storage drawer, the rear legs cannot be accessed by removing

the warming drawer or premium storage drawer. It will be

necessary to adjust the rear legs from outside the range. Use

wrench or pliers to lower the front and rear leveling legs one-

half turn.

A. Rear levering leg

B. Wrench or pliers

C. Front leveling leg

nsks As'st

p B ccsck®

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip

bracket to floor or wall per installation

instructions.

Slide range back so rear range foot is engaged

in the

slot of the anti-tip

bracket.

Re-engage

anti-tip

bracket

if range is moved.

Do not operate range without

anti-tip

bracket

installed

and engaged.

Failure to follow these instructions

can result in death

or serious

burns to children

and adults.

Remove the anti-tip bracket from where it is taped inside the

storage drawer or warming drawer.

Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor, you can use the wall

mounting method. If you are installing the range in a mobile

home, you must secure the range to the floor.

Determine and mark centerline of the cutout space. The

mounting can be installed on either the left side or right side of

the cutout. Position mounting bracket against the wall in the

cutout so that the V-notch of the bracket is 12%6" (31.9 cm)

from centerline as shown.

Centerlioe

A. 12_"

(31.9 cm)

B. Bracket V-notch

Drill two 1/8"(3 mm) holes that correspond to the bracket holes

of the determined mounting method. See the following

Rear position

Front position

Diagonal (2 options)

illustrations.

Floor Mounting