AirGenerate airtap Manual de instalación - Página 4

Navegue en línea o descargue pdf Manual de instalación para Calentador de agua AirGenerate airtap. AirGenerate airtap 8 páginas.

Step-by-Step Instructions

Remove and unwrap the AirTap

keep all the parts within reach and in sight throughout the process.

Make sure that the AirTap

A Plug the unit into a typical household 115V plug and let it run for 4 to 5 minutes.

Touch the heating copper tube in the back and feel the heating taking place.

B Unplug the AirTap

. If the copper tube was hot to the touch and you heard

™

the quiet humming of the fan, the AirTap

MAKE SURE NOT TO RUN THE AIRTAP™ UNINSTALLED FOR MORE THAN 7 MINS.

Now you are ready to prepare the water heater for installation.

1. Turn off the electricity to the water heater. Use a tester or voltmeter to ensure

that the circuit to the water heater is powered down. In case of a gas/

propane water heater, turn off the gas/propane valve.

2. Turn off the cold water inlet to the water tank and open the hot water tap

to remove some water to depressurize the water tank.

3. Make sure that the unit has access to a drain, so that the condensate

produced by the AirTap

™

the level of condensate can be up to 1 quart per day.

4. On most electric (or gas) water heaters, the inlet and outlet connections

consist of two ¾" nipples extending from the top of the tank. First, disconnect

the hot outlet pipeline from the nipple, then using your pipe wrench, remove

the ¾" nipple extending from the hot outlet port of the water heater.

and all parts from the box. It helps to

™

unit works correctly before installing it.

™

unit is functioning normally.

™

can escape. During periods of high humidity,