Jancy Engineering JB2400 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Equipos de construcción Jancy Engineering JB2400. Jancy Engineering JB2400 16 páginas.
Imprimir páginaoperating instructions ( before you begin )
Remove all contents from packaging and inspect to ensure no damage was incurred during shipping. Your JB2400
package should also include the following:
always disconnect Jancy slugger bender from power source before maKing adJustments.
WARNING: Ensure the Jancy Slugger Bender switch is in the off position before plugging in the
power lead to the power outlet. Ensure the power cable is not in a position where it can come into
contact with any moving parts of the Jancy Slugger Bender.
WARNING: Jancy Bender weighs approximately 600 pounds, use care in handling machine.
WARNING: do not insert forks into cabinet to load or unload the machine. doing so may cause damage
to machine components.
- Remove all packaging material and shipping bands that secure the machine to the pallet.
There are two methods for removing the machine from the shipping pallet.
Method #1(preferred method):
Remove the two 2X6 support boards from under the machine by removing the screws at both ends.
With some assistance, raise the machine slightly to remove the remaining two 2X6 boards.
If possible, build a ramp at the front of the machine.
With some assistance, roll the machine off of the pallet using caution not to drop it to the ground or onto
anyone's feet or hands.
Method #2:
Lift machine off of pallet by using a forklift, or overhead lift, etc.
Position a single lifting strap around the upper box tube at the front end of
the machine (as pictured).
ONLY RAISE THE MACHINE HIGH ENOUGH TO REMOVE THE PALLET,
SET THE MACHINE ON THE GROUND AS SOON AS POSSIBLE.
Alternatively: Remove the two middle 2X6 boards from under the machine
by removing the screws at both ends. Position the forks under the lower frame. Only lift the machine
high enough to remove the shipping pallet.
have a qualified electrician install the appropriate power connector to the end of the
power cord.
6
description
operator's manual
5/8" allen Wrench
3/32" allen Wrench
3/4" X 6" HITCH PIN
Jancy White grease
pressure Die cam control hanDle
Additional Jancy White Grease in a can can be
purchased by the can (#JB0810) or 12 can case (#JB0811)
getting started
cAUTION!
#
part
qty
LIT115
1
JB000108 1
0070092
1
JBL26169 1
JB0810
1
0151333
2
Attach lifting strap as pictured