Jandy AquaPure Ei Series Instrucciones - Página 3

Navegue en línea o descargue pdf Instrucciones para Sistemas de filtración de agua Jandy AquaPure Ei Series. Jandy AquaPure Ei Series 4 páginas. Replacement kits for models apure35plg / 35plgc
También para Jandy AquaPure Ei Series: Manual (8 páginas)

Imprimir página

4. Power Pack Wiring Instructions

WARNING

When using electrical products, basic precautions

should always be followed, including the following:

• DANGER: RISK OF ELECTRIC SHOCK WHICH

CAN RESULT IN SERIOUS INJURY OR DEATH.

Before attempting installation or service, ensure

that all power to the device is disconnected/turned

off at the circuit breaker. Connect only to a circuit

protected by a ground-fault circuit-interrupter

(GFCI).

• Grounding is required. The unit should be

serviced by a qualified service representative and

should be properly grounded and bonded.

• Install to permit access for servicing.

• Please read all cautions and safety instructions

in the Important Safety Instructions section of

the Jandy AquaPure

(H0335900 or H0342400). Before attempting

any electrical wiring, be sure to read and

follow safety instructions. Wiring should only

be attempted by a qualified professional.

A. Connection to an AquaLink

Control System or PDA (Optional)

The Jandy AquaLink RS or PDA is a multi-function

pool controller which can fully control the function

of the Jandy AquaPure Ei chlorine generating device.

Adjustment of the chlorine production rate can be

controlled from the main menu of the Jandy AquaLink

RS or PDA. The AquaLink RS or PDA offers individual

pool and spa settings for output percentage. Refer to

the AquaLink RS or PDA Owner's Manual for more

information.

NOTE The Jandy AquaPure Ei chlorine generating

device will communicate with all AquaLink

models Rev. K or later.

B. Verify the Controller Type on the Power

Pack is Set Correctly

Before wiring to an AquaLink RS Control System,

the controller type must be set to JANDY L/M to

allow communication between the power pack and the

AquaLink RS Control System. The default controller

type setting on the power pack is Jandy L/M. Follow

the instructions below to verify the controller type is set

correctly.

NOTE The controller type must be set correctly before

making the wiring connection between the

power pack and the AquaLink, otherwise the

power pack may be locked out of the AquaLink.

Series owners manual

To verify the controller type is set correctly:

1. Apply power to the power pack.

2. Wait for the start-up sequence to complete.

3. Press and hold the OUTPUT button for

approximately four (4) seconds. After four (4)

seconds, a controller type will be displayed on the

screen.

4. Verify that the JANDY L/M controller type appears

on the display. If the contoller type is not set to

JANDY L/M, keep the OUTPUT button pressed to

toggle through the list of contollers. Each controller

will be displayed on the screen for two (2) seconds.

Release the OUTPUT button when JANDY L/M

appears on the display.

C. Wiring to the AquaLink RS Control

System or PDA

1. Ensure that all power to the power pack and the

controller is disconnected/turned off at the circuit

breaker.

2. Remove the screws attaching the cover to the back

plate and prop the cover up to expose the terminals

(see Figure 6).

NOTE: Be careful not to pull the ribbon cable that is

connected to the Power Supply and the Cover.

Comm Hole

Figure 6.

Accessing and Wiring to the Power PCB

Page 3

Cable Tie