KitchenAid KEBC149BSS Manual de instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Horno KitchenAid KEBC149BSS. KitchenAid KEBC149BSS 16 páginas. 24" (60 cm) electric built-in oven

Imprimir página

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Phillips screwdriver

Flat-blade screwdriver

Measuring tape

Drill (for wall cabinet installations)

1" (2.5 cm) drill bit (for wall cabinet installations)

Level

Parts needed

Wire connectors

Parts supplied

CSA approved conduit connector

Two 4 x 25 mm self-tapping screws

Check local codes. Check existing electrical supply. See

"Electrical Requirements."

It is recommended that all electrical connections be made by a

licensed, qualified electrical installer.

INSTALLATION REQUIREMENTS

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Cabinet opening dimensions that are shown must be used.

Given dimensions provide minimum clearance with oven.

Recessed installation area must provide complete enclosure

around the recessed portion of the oven.

Grounded electrical supply is required. See "Electrical

Requirements" section.

Electrical supply junction box should be located 3" (7.6 cm)

maximum below the support surface when the oven is

installed in a wall cabinet. A 1" (2.5 cm) minimum diameter

hole should have been drilled in the right rear or left rear

corner of the support surface to pass the appliance cable

through to the junction box.

NOTE: For undercounter installation, it is recommended that

the junction box be located in the adjacent right or left

cabinet. If you are installing the junction box on rear wall

behind oven, the junction box must be recessed and located

in the upper or lower right or left corner of the cabinet to allow

the oven to fit into the cabinet opening.

Oven support surface must be solid, level and flush with

bottom of cabinet cutout. Floor must be able to support an

oven weight of 140 lbs (63.5 kg).

IMPORTANT: To avoid damage to your cabinets, check with

your builder or cabinet supplier to make sure that the

materials used will not discolor, delaminate or sustain other

damage. This oven has been designed in accordance with

the requirements of CSA International and complies with the

maximum allowable wood cabinet temperatures of

194F° (90°C).

Undercounter Installation (with cooktop installed above):

Ovens approved for this type of installation have an approval

label located on the top of the oven. Refer to undercounter

installation instructions for cutout dimensions and approved oven

cooktop combinations (separate sheet).