Empire BF-10BC-2 Instrucciones de instalación y manual del usuario - Página 9
Navegue en línea o descargue pdf Instrucciones de instalación y manual del usuario para Calentador de gas Empire BF-10BC-2. Empire BF-10BC-2 20 páginas. Unvented
Imprimir páginaOn Sheet Rock Wall
1. After locating mounting holes, drill (4) 5/16" (8mm) diameter
holes into the wall.
2. Insert (4) plastic expansion anchors provided into the holes.
3. Tighten (4) #10 x 1" (25mm) screws provided into the plastic
expansion anchors. Do not completely tighten screwheads to
the plastic expansion anchors, leave a 1/8" (3mm) gap between
screwheads and plastic expansion anchors.
4. Mount heater onto the (4) screwheads and complete tightening
the screwheads to the plastic expansion anchors.
Attention! Use the following steps to properly align the upper
louver and the reflector with the heat shield.
a. When replacing upper louver, be sure the bottom lip of upper
louver goes behind the heat shield.
b. When replacing reflector, be sure the top lip of reflector
goes in front of the heat shield.
5. Connect the gas line.
OPTIONAL FLOOR STAND INSTALLATION
1. Align clearance holes on floor stand with screw holes on bottom
of heater, as shown in Figure 6.
2. Attach floor stand to heater with (4) screws provided with floor
stand.
3. Connect the gas line.
Installation on Rugs and Tile
If this appliance is installed directly on carpeting, tile or other com-
bustible material, other than wood flooring, the appliance shall be
installed on a metal or wood panel extending the full width and
depth of the appliance.
Attention: Optional SRS-18 Floor Stand meets requirement.
The base referred to in this section does not mean the fire-proof
base as used on wood stoves. The protection is for rugs that are
extremely thick and light colored tile.
16013-6-0314
WALL MOUNT INSTALLATION
Figure 5
Figure 6
Page 9