Avatar EMK-25 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Teclado Avatar EMK-25. Avatar EMK-25 12 páginas. Midi keyboard
También para Avatar EMK-25: Manual del usuario (8 páginas)

Imprimir página

6. Pads

◇ The pads can be used to trigger drum hits or other samples in your software. The

pads are velocity-sensitive, which makes them very responsive and intuitive to play.

◇ The pads work on Note or CC N mode.

◇ Aftertouch function exists by default in Note mode.

◇ MIDI Channel can be adjusted in CC N mode.

7. BANK A/B

◇ Press the BANK A/B button to switch the pads to group A(orange indicator light) or

group B (green indicator light)

◇ The corresponding pads of group A are PAD1-PAD9; the corresponding pads of group

B are PAD10-PAD18.

8. Octave UP/DOWN

◇ Use these buttons to shift the keyboard's range up or down (up to four octaves in

both directions). When it is higher or lower than the center octave, the corresponding

Octave button will light. The corresponding button will ﬂash the same times as that

of octaves you increase or decrease.

9. Arpeggiator

◇Press ARP button to turn the Arpeggiator on or o .

◇Hold down ARP button, you can press a key on the keyboard to modify the settings

of arpeggiator. There is description above each key.

◇When the built-in metronome is on, holding down the ARP button and turning the

Selection knob can adjust the speed of the built-in metronome.

10. Metronome

◇ When the ARP or NOTEREPEAT is on, the TAP button will ﬂash at the current

metronome tempo.

◇ When metronome is on, press TAP button at the desired rate to determine the tempo

of the metronome.

◇ When synchronizing an external metronome, the TAP button will ﬂash at the external

metronome tempo.