Garden Treasures 247668 Instrucciones de montaje - Página 2

Navegue en línea o descargue pdf Instrucciones de montaje para Fuente al aire libre Garden Treasures 247668. Garden Treasures 247668 3 páginas. Four tier octagon fountain

Imprimir página
1.
Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Place the under basin on a flat surface and position the pump to the central part of the under basin. Route the pump power cord from the cord slot
on the bottom of the under basin via cable pipe attached at inner side of the under basin. Insert the plastic cover into the cable pipe (Fig.1)
4.
Attach the middle basin to the holder by lining up the corresponding fittings and
turn until middle basin locked unto the holder. (Fig.2)
5.
Insert the one end of the water supply tube into the outlet on the pump. Then lead
the other end of the water supply tube upward via holder and middle basin. Attach
the middle basin with holder to the under basin by lining up the corresponding
fittings and turn until under basin locked into the holder. (Fig.3)
6.
Continue to lead the water supply tube via the hole in the upper basin. Attach the
upper basin to the middle basin by lining up the corresponding fittings and turn
until upper basin locked unto the middle basin. (Fig.4)
7.
Then connect the water supply tube to the connector attached at the bottom of the
top fountain. Attach the top fountain to the upper basin by lining up the
corresponding fittings and turn until top fountain locked unto the upper basin.
(Fig.5)
8.
Fill the under basin with certain clean water. The water level should be
approximately 30mm (1.18inch) below the rim of the under basin. Then add water
into the middle, upper basin, up to an optimum level, until water just flowing from
the basin. (Fig.6)
9.
Plug the power cord from pump into the electrical outlet. Turn the power source on.
The fountain will begin to work.
10. To ensure fine watering effect, please make sure that the markings on the
connection area "↑-↓" are just wedged together before the connection of each
pillar and basin. Then assembly action can be carried out.
11. To eliminate the possibility of water damage to areas around your fountain, check
for leaks and excessive splashing after the initial setup of your fountain. It is
highly recommended that this fountain be placed in an area that will not be
damaged should the area come in contact with liquid.
12. Do not leave your fountain running for extended periods of time when no one is
present to observe the performance.
13. Check the area around your fountain on a regular basis to ensure that there is no
leakage.
Instruction For Installing Water Seal Plastic Cover
1.
Pull the plastic cover off the cable pipe before installing the pump.
2.
Pass the pump plug through the cable pipe, lead the pump cable our from the
leading wire notch. Then put the pump into the basin steadily.
Pump Maintenance Instructions
•
Regular cleaning of the pump is necessary.
•
Keep water clean to prolong the life of pump.
•
Clean pump when it is dirty or when a drop in performance is
detected. Use warm, soapy water and a stiff brush for heavily
stained surfaces. Do NOT use harsh chemicals, as this will
damage the surface finish.
•
Failure to clean the pump will result in overheating and voiding of
the warranty.
•
Use a filter on pump if available.
•
Disconnect the power and empty the reservoir if the fountain will
not be used for an extended time.
•
Do NOT operate fountain in temperatures below 41°F (5°C).
Freeze damage may occur. If the fountain is kept outdoors in
freezing temperatures, make sure all water is removed and the unit
is completely dry.
To disassemble pump for cleaning:
1.
Always disconnect pump from the power source before cleaning.
2