Jandy Jandy Pro Series Manual de instalación y funcionamiento - Página 14

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Controlador Jandy Jandy Pro Series. Jandy Jandy Pro Series 16 páginas. Single element cartridge pool & spa cs filters
También para Jandy Jandy Pro Series: Manual del usuario (12 páginas), Manual de instalación (16 páginas), Manual de instalación y funcionamiento (20 páginas), Manual del usuario (20 páginas), Manual (8 páginas), Manual de inicio rápido (2 páginas), Manual de instalación y funcionamiento (20 páginas), Instrucciones de instalación (2 páginas), Manual de instalación y funcionamiento (16 páginas), Manual de instalación y funcionamiento (16 páginas)

Imprimir página
Jandy Jandy Pro Series Manual de instalación y funcionamiento
Page 14
ENGLISH
Table 4.
Troubleshooting Guide
Fault Symptom
Water is not clear.
Low water flow.
Short filter cycles.
High pressure on start-up.
Dirt returns to pool.
Jandy
DE Pool Filters
®
Possible Problems
Insufficient disinfectant level.
Incorrect pool chemistry.
Heavy bathing and/or dirt loads.
Insufficient running times.
Filter is dirty.
Hole in filter element.
Filter system strainer baskets dirty.
Air leaks on suction side of pump.
Restrictions or blockage in either
suction or return lines.
Filter grids need to be cleaned or
replaced.
Pool water level too low.
Pump not primed.
Pump impeller vanes blocked.
Pump operating under speed (low
voltage).
Presence of algae clogging filter.
Incorrect water chemistry.
Strainer baskets not being used and/or
broken. (Allow debris into pump.)
Pump output exceeds design flow rate
of filter.
Ineffective cleaning.
Small eyeball fitting in Pool/Spa.
Partially closed valve on return line.
Too large of pump.
Filter grids dirty.
Hole in filter grid fabric.
Worn o-ring seal inside filter.
Cracked manifold.
|
Installation & Operation Manual
Check and adjust disinfectant level.
Test and adjust water chemistry.
Adjust filter time and/or water chemistry.
Increase pump run time.
Backwash filter per instructions.
Replace filter grids.
Check and clean skimmer and pump
baskets.
Check all connections between pool
intake and pump.
Check all lines for debris or partially
closed valves.
Clean or replace filter grids per
instructions.
Fill pool so level is above pump inlet line.
Fill pump with water at basket and replace
lid.
Technician required.
Technician or electrician required.
Check disinfectant content.
Check pH, total alkalinity and TDS.
Replace baskets.
Check pump performance.
Clean or replace filter grids per
instructions.
Replace with larger diameter fitting.
Check and fully open all valves on return
line.
Check pump and filter selection.
Clean filter grids per instructions.
Replace filter grid per instructions.
Replace o-ring.
Replace the manifold assembly.
Solutions