Jandy Pro Series PHPF.50 Instrucciones - Página 3
Navegue en línea o descargue pdf Instrucciones para Bomba de agua Jandy Pro Series PHPF.50. Jandy Pro Series PHPF.50 4 páginas. Lid w/ locking ring and seal, lid seal and lid o-ring, and basket, replacement kit
Imprimir página
Jandy
Pro Series PHP(F/M), WFTR, and MHPM Pumps, Lid w/ Locking Ring and Seal, Lid Seal and O-ring, and
®
2.
Replace the lid o-ring.
a. Comply with the warnings and follow Steps
1-5 in Section 2.1, Opening Pump.
b. Clean the lid o-ring groove.
c. Place the new o-ring into the lid o-ring groove.
Skip Step 3 and go to Step 4.
3.
Replace the lid seal.
a. Comply with the warnings and follow Steps
1-5 in Section 2.1, Opening Pump.
b. Clean the lid groove.
c. Note that one (1) side of the lid seal has two
(2) ribs and the other side has one (1) rib.
Insert the new lid seal into the lid groove,
placing the side with two (2) ribs into the
groove. See Figure 4.
Cross Section of Lid Seal
Place side with two
ribs into lid groove.
Figure 4. Cross Section of Seal
4.
Go to the appropriate section:
2.3 Replacing Pump Debris Trap Basket
(Kit R0448900)
2.4 Replacing Lid with Locking Ring and Seal
(Kit R0448800)
2.5 Completing Procedures
|
Basket
Replacement Kit Instructions
2.3 Replacing Pump Debris Trap Basket
(Kit R0448900)
Follow all filter manufacturer's instructions. Never
attempt to assemble, disassemble or adjust the
filter when there is pressurized air in the system.
Starting the pump while there is any pressurized
air in the system can cause the filter lid to be
blown off, which can cause death, serious
personal injury or property damage.
1.
Comply with the warnings and follow steps 1-5 in
Section 2.1, Opening Pump.
2.
Lift the pump debris trap basket out of the pump.
3.
Before installing the new debris trap basket,
remove all debris from the pump.
4.
Place the new pump debris trap basket into the
pump. Make sure that the slot of the basket is
aligned with the positioning tab inside the pump
housing. (See Figure 1.) If aligned properly, the
basket will drop easily into place. Do not force it
into place.
A misaligned basket will cause the lid to be
improperly seated, allowing an air leak, which
could result in pump damage.
5.
Go to the appropriate section:
2.4 Replacing Lid with Locking Ring and Seal
(Kit R0448800)
2.5 Completing Procedures
Page 3
WARNING
CAUTION