Avaya IP Office 4600 Series Manual de instrucciones de instalación - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Teléfono IP Avaya IP Office 4600 Series. Avaya IP Office 4600 Series 8 páginas.
Imprimir página
DHCP Installation
DHCP Phone Installation
4600 Series IP Telephone Installation
IP Office
1. Connect the 1151A1 Power Unit to a mains power socket and switch
on. The green Power On lamp on the Power Unit should come on.
2. Connect the longer LAN cable supplied with the IP telephone from the
network LAN socket to the power unit's LINE socket.
•
Note: The 400B2 Power Adaptor used for providing power for 4600
Series IP Telephones is not compatible with the sockets on IP Office
units. We therefore advise against the direct connection of these
adaptors.
3. Connect the shorter LAN cable supplied with the IP telephone from the
Power Unit's PHONE socket to the socket with a LAN port symbol ( )
at the back of the IP telephone.
4. The phone's message indicator should glow red for a few seconds. The
phone will then begin its software loading.
5. After a short delay the phone should display Initializing and then
Loading.... The loading phase may take a few minutes.
•
If the phone displays No Ethernet check the connection to the LAN.
6. The phone displays DHCP and a timer. After a few seconds it should
complete DHCP negotiation with the Control Unit. If the timer reaches
more than 60 seconds then you should suspect a error in either network
or DHCP operation.
7. The phone requests the 46xxupgrade.scr file from the TFTP server
(Manager). This should be visible in the Manager's TFTP Log.
8. The phone now requests additional files according to the instructions it
found in the 46xxupgrade.scr file. The phone will go through a cycle of
requesting files, loading files and then transferring the files into its flash
memory.
9. Following file loading the phone displays Ext. =. Enter the extension
number you want applied to the phone and press #.
•
Wrong Set Type is displayed if you try to use the extension number
of an existing non-IP extension.
10. The phone displays Password =. Just press #.
11. The phone will briefly display the time and date and then its extension
number.
12. Test that you can make and receive calls at the extension.
13. Using Manager, you can now open the Control Unit's configuration and
alter the extension and user settings as required:
•
In the list of extensions, the
new extension will have been created matching the extension
number entered above. In the extension's VoIP tab, the
Compression Mode default is Automatic Selection. If this needs
to be changed select G.729(a) 8K CS-ACELP.
•
In the list of users, a new user will have been created matching the
extension number entered above.
icon indicates VoIP extensions. A
40DHB0002UKCJ - Issue 5 (08/03/2002)
Page 6
Page 6