Gardena 4000/4 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Bomba de agua Gardena 4000/4. Gardena 4000/4 18 páginas. Pressure tank unit electronic plus with dry-running safety
También para Gardena 4000/4: Manual de instrucciones (19 páginas)

Imprimir página

Finding Faults

Important !

Unplug the pump.

Check the pump for possible

faults such as:

➔ Faulty or leaking back-flow

preventer at the end of

the suction hose

➔ Pump and suction hose

are not filled up with the

liquid to be pumped

➔ Backflow valve switch set

to START and was not set

to RUN once the pump

began pumping

Storing Your Pressure Tank Unit

Disposal

(in accordance with

RL 2002 / 96 / EC)

Yellow LED is lit

The "automatic self-priming mode" is no longer active and the

unit is no longer supplying water (e.g. no water in the container

or borse or the filter is dirty).

Note: The pump can be restarted at any time by pressing the

RESET button or by "re-plugging".

Green and yellow LEDs flashing quickly and alternately

(four times a second)

Warning: There is a leak in the pipe system.

The pump switches on and off because of a leak. If the pump

switches on and off more than 7 times within 2 minutes, the

control unit issues a warning via flashing LEDs and the motor

switches itself off.

Note: The pump can only be restarted by "re-plugging".

➔ Suction hose end is not

submerged into the liquid

➔ Outlet too low

➔ Suction hose or connec-

tions are not water-tight

➔ Suction filter clogged

➔ Air cannot escape on

delivery side since release

points are closed etc.

➔ Delivery pipe or consumer

are not water-tight

➔ The pump switches on and

off because of a leak. If the

pump switches on and off

more than 7 times within

Always remove the mains plugs before working on the

pump.

Protect your pump against frost.

➔ Set the switch to START and empty the

pump via the drain screw.

➔ Store you pump away from frost.

The product must not be added to normal household waste. It

must be disposed of in line with local environmental regulations.

v Important : Make sure that the unit is disposed of via your

municipal recycling collection centre.

2 minutes, the control unit

issues a warning via flash-

ing LEDs and the motor

switches itself off.

Clear the fault. Plug in the

pump in order to start again

operation of the pump.

Shouldn't the pump start

priming, although you have

repeatedly pressed the

RESET button, please contact

one of our GARDENA Service

Centres (addresses you will

find on the rear side).