KitchenAid KICU265HSS1 Instrucciones de instalación y manual de uso y mantenimiento - Página 7
Navegue en línea o descargue pdf Instrucciones de instalación y manual de uso y mantenimiento para Campana de ventilación KitchenAid KICU265HSS1. KitchenAid KICU265HSS1 13 páginas. 36", 48" island canopy range hood
También para KitchenAid KICU265HSS1: Manual de piezas (4 páginas)
Imprimir página
install chimney
sections
1_
,
Connect vent to damper or
hood and seal all connections with
duct tape.
upper chimney
support
system
frame
4,
Position upper chimney
section on support system frame and
secure with two screws.
upper
chimney
I--3
Io
chimney
Fit lower chimney section over upper
chimney section. Note: clip hole
arrows must point toward ceiling.
Check for proper position. Then
secure upper and lower chimney
sections to support system frame with
four screws.
upper
[_]
; , ney n
clips_[_
lower
'2ney
/
chimney
holes
chimney
holes
trim
\clip
5
_
Cut upper chimney trim to
correct length. Be careful not to bend
strips while cutting. Slide clips into
trim. Postion to align with chimney
holes. Push trim strips so that dips
snap into holes.
o_p! ng
Place filters in canopy
ni
so rear edge is over flange.
Press filters up into position.
Check operation
17. Turn power
on.
control panel
location
[]
The island canopy hood
controls are located in a grey panel on
underside of the canopy. To open the
panel, press on the front edge of
panel and release. The control panel
will drop down.
o lr-4Ole
1
r_01
light
switch
40
tll
11111111111111
F
blower
blower
speed
switch
switch
[] Check the operation of the
range hood:
[]
Move light switch to "1" position.
The light should turn on.
[]
Move blower switch to "1"
position. The blower should
operate.
[]
Move the blower speed switch to
the far left; blower speed should
be LOW. Move blower speed to
right; blower speed should
gradually increase until you reach
HIGH speed at far right.
[]
Move blower and light switches to
"0" position to turn blower and
light off.
If range hood does not operate:
[]
Check that the circuit breaker is
not tripped or the house fuse
blown.
[]
Disconnect power supply. Check
that wiring is correct.