Corvette BLU-C5 Manual de instalación - Página 2

Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles Corvette BLU-C5. Corvette BLU-C5 11 páginas. Streaming module for 1997-04 corvette
También para Corvette BLU-C5: Manual de instalación de inicio rápido (9 páginas)

Imprimir página

PRODUCT SAFETY & DISCLAIMER

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE

PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY

▪

This installation guide is provided as a GENERAL installation guide, some vehicles vary and

may require additional steps. We do not accept responsibility for third party labor charges

or modifications. Exercise due-diligence when installing this product.

▪

We do not accept any responsibility for vehicle damage or personal injury resulting from

the installation of this product.

▪

Careless installation and operation can result in equipment damage

Requirement

1997-04 Corvette WITH ORIGINAL RADIO

Introduction

The new BLU-C5 module (V 2.24), adds music streaming capabilities to all C5

with original Theftlock CD or Tape radio (Bose or non-Bose). Installation options

include behind the radio cavity using the PXHGM4 harness OR to the 10-pin CD

plug in trunk/hatch using the PXHGM2 harness. Irrespective of install location,

the factory 12-disc changer (if present) must be disconnected. Purchase our

A2D-C5

to retain CD changer operation.

Note: The BLU-C5 support Bluetooth A2DP2 (music streaming) but does NOT

support hand-free calls (HPF). Purchase our

streaming.

For more, go to frequently asked question at the end of this guide.

Installation 1:

Installing module behind radio requires the PXHGM4

installation harness

To install module at the radio, the PXHGM4 installation

harness (See Fig.2) is required. When installed at the radio,

The BLU-C5 will turn on/off with radio power button. It is

also possible to install the BLU-C5 to 10-pin CD plug in

trunk/hatch using the PXHGM2 installation harness.

Go to installation 2 on page 3 for details.

A2DIY-C5

for hands-free and music

Click links below for radio removal videos:

Radio removal -

https://www.youtube.com/watch?v=Gcrlufo1ctc

https://www.youtube.com/watch?v=WTbWYNJTSDs

Locate radio 20-pin plug, press black release tab to disconnect from

radio (See Fig. 1)

2. Connect radio 20-pin plug (from step 1), to matting 20-pin socket (white)

on installation harness (See Fig. 2).

3. Connect installation harness 20-pin black/gray plug (See Fig. 2) to radio

20-pin socket vacated in step 1

4. Ensure plugs/connectors are snug

5. With optional AUX input: Connect included 3 ft. aux cable to module jack

and route other end to front of the dash or where aux device will reside.

6. With optional USB-C charging kit—Go to page 7 for installation steps

7. Proceed to "Pairing" on page 5

Fig. 1

Fig. 2

PXHGM4 harness