Lexmark E238 Cómo reiniciar - Página 2

Navegue en línea o descargue pdf Cómo reiniciar para Impresora Lexmark E238. Lexmark E238 2 páginas. How to reset the photoconductor page count through the printer's configuration menu
También para Lexmark E238: Configuración e instalación (2 páginas), Referencia rápida (2 páginas), Manual de servicio (5 páginas)

Imprimir página

1. Press and release the Cancel button (

you get lost, you can press and hold the Cancel button to jump to home state (top four lights on).

2. Press and release the Cancel button until the Toner Low (

3. Press and hold the Continue button until all of the lights flash.

4. Then release the button. When the Toner Low light is once again the only light left on, the photoconductor

page count should be reset to zero.

4. Return the printer to normal mode. To do this:

Power it off for five seconds and then turn it back on.

5. Print a menu settings page. To do this:

When the Ready (

one or two pages will print out.

6. Check the photoconductor reading on the menu settings page. To do this:

1. Look for a section labeled Cartridge Information and locate the word Photoconductor under that

heading.

2. Confirm that the photoconductor level reading is OK or close to 100%.

3. If the photoconductor reading is low, try printing 10 - 20 pages.

4. Print the menu settings page(s) again. Confirm that the photoconductor level reading is OK or close to

100%.

5. If the photoconductor reading is still low, refer to the Configuration Settings page you printed in Step 2.

6. Confirm that Reset Photoconductor Counter is listed on the page.

Also confirm that the light sequence for the photoconductor counter is the Toner Low light.

If the light sequence is correct, try repeating this entire procedure again from the beginning to reset

the counter once more.

If a different light sequence is listed for the photoconductor counter, repeat the procedure but this

time, instead of stopping at the Toner Low light (Step 3.2), press the Cancel button until the

operator panel shows the light sequence that corresponds to the one listed on the Configuration

Settings page. Continue with the remainder of the procedure as before to reset the counter again.

7. If the photoconductor reading is still low after the page reset procedure has been performed twice, the

printer may require service.

For more information about resetting this counter, refer to the instruction sheet that shipped with the new photoconductor

kit.

http://support.lexmark.com/index?pmv=print&page=content&locale=EN&userlocale=EN_US&id=HO2496

) to move sequentially from one menu item to another.

) light is on, press the Continue button once. The Ready light will begin flashing and

) light is the only light left on.

9/12/16, 8:14 PM

NOTE:

Page 2 of 2