KitchenAid Electric Built-In Microwave/Oven Combination Manual de instrucciones de instalación - Página 5
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Horno microondas KitchenAid Electric Built-In Microwave/Oven Combination. KitchenAid Electric Built-In Microwave/Oven Combination 20 páginas. Microwave oven with convection
También para KitchenAid Electric Built-In Microwave/Oven Combination: Manual de uso y mantenimiento (20 páginas)
Imprimir página
Prepare Built-In Microwave/Oven
Combination
1. Decide on the final location for the oven. Avoid drilling into or
severing existing wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior to
installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
4. Remove the hardware package from inside the bag
containing literature.
5. Remove and set aside racks and other parts from inside the
oven.
6. Move oven and cardboard close to the oven's final location.
Remove Oven Door
IMPORTANT: Use both hands to remove oven door(s).
1. Open the oven door.
2. Locate the oven door latches in both corners of the oven
door, and rotate the latches forward to the unlocked position.
A. Oven door latch in locked
position
3. Grasp the edges of the oven door with both hands and close
the oven door until it will no longer close. Lift and pull oven
door toward you and remove. Set the oven door(s) aside on a
covered work surface.
INSTALLATION INSTRUCTIONS
A
B. Oven door latch in unlocked
position
Make Electrical Connection
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This oven is manufactured with a neutral (white) power supply
wire and a cabinet-connected green (or bare) ground wire twisted
together.
1. Disconnect power.
2. Feed the flexible conduit from the oven through the opening
in the cabinet.
3. Remove junction box cover, if it is present.
4. Install a UL listed or CSA approved conduit connector to the
junction box.
B
A. UL listed or CSA approved conduit connector
5. Route the flexible conduit from the oven to the junction box
through a UL listed or CSA approved conduit connector.
6. Tighten screws on conduit connector.
7. See "Electrical Connection Options Chart" to complete
installation for your type of electrical connection.
Electrical Connection Options Chart
If your home has:
4-wire
3-wire
WARNING
Electrical Shock Hazard
A
Go to section:
4-wire Cable from Home
Power Supply
½"
(1.3 cm)
3-wire Cable from Home
Power Supply
½"
(1.3 cm)
5