Gardena 1407 Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Césped y jardinería Gardena 1407. Gardena 1407 12 páginas. Flower box watering set
También para Gardena 1407: Manual de instrucciones (11 páginas), Manual de instrucciones (11 páginas), Manual del usuario (13 páginas), Manual de instrucciones (12 páginas), Manual de instrucciones (11 páginas)

Imprimir página

8. Maintenance, care, storage

Attention ! Disconnect

the mains plug before

carrying out any work on the

system !

Cleaning the filter (fig. F)

The pump is almost maintenance-

free.

It has an integrated filter which

needs to be cleaned in the follow-

ing way, after the system has

been shut-off :

1. Press both orange locking

knobs

and remove the

base of the pump (fig. F).

9. Faults

Fault

Pump does not run.

No water is delivered.

The watering cycles are

incorrect.

The system still runs after the

pump has been turned off.

If you have any problem with

your Flower Box Watering system,

please contact our Customer

Service or return the defective

unit together with a short descrip-

tion of the problem directly to

one of the GARDENA Service

Centres listed on the back of

this leaflet.

2. Take out the filter

rinse in clean water.

3. Replace the filter into the

suction base.

4. Re-connect the base to

the pump. Ensure that locking

knobs snap firmly into posi-

tion.

Attention ! The housing

of the pump is sealed at

the thread. Any work on elec-

trical parts must only be carried

out by GARDENA Service.

Possible cause

Mains connector or pump

connector are not plugged in.

Soil Moisture Sensor / Rain

Sensor indicates moisture.

Container is empty.

The pump filter

is blocked.

The adjustment knob

the transformer is set in between

programmes.

Inline Drip Heads are installed

lower than water level in con-

tainer.

If covered under guarantee,

please include the completed

and signed warranty card.

We expressly point out that,

in accordance with the product

liability law, we are not liable

for any damage caused by our

units if it is due to improper

and

In frost affected areas the pump

and transformer must be stored

in a dry place.

Device may not be added to nor-

mal household refuse but must

be disposed of in the technically

correct way.

Remedy

Insert the mains plug in the outlet

socket, or the pump connector

plug in the socket at the trans-

former.

Wait until the Soil Moisture

Sensor / Rain Sensor has dried

out sufficiently.

Fill container with water.

Clean the pump filter

(section 8.1).

Set the adjustment knob exactly

onto desired position.

Choose another location for the

container, where the water level

is below the Inline Drip Heads.

Install an Inline Drip Head to vent

the system.

repair or if parts exchanged are

not original GARDENA parts

or parts approved by us, and,

if the repairs were not carried

out by a GARDENA Service

Centre or an authorised spe-

cialist. The same applies to

spare parts and accessories.

Disposal :

(in accordance with

RL 2002 / 96 / EC)