Gardena Filter Set 5000 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Césped y jardinería Gardena Filter Set 5000. Gardena Filter Set 5000 6 páginas.

Imprimir página
Gardena Filter Set 5000 Manual de instrucciones
G
3. Mode of Operation of the Filter
!
Water intake
Connection for the hose to the pump in the pond.
"
"
Mechanical filtering
Foam filter mat for filtering out coarse dirt particles.
§
§
Biological filtering
The pollutants and surplus nutrients are bonded to the filter
$
pellets and broken down.
!
$
Bio-surface filters
The basis for biological water treatment by building up micro-
organisms.
%
%
Water outlet
Connection for the hose to return the purified water to the
pond.
4. Putting into Operation
Assemble the filter set :
1. Unscrew the filter cover
remove the contents.
2. Insert both connection pieces
0
container and place both sealing rings
pieces from inside.
9
3. Screw filter
4. Screw the threaded section with outlet
the upper connection piece
8
The outlet should point upwards.
5. Place bio-surface filters
7
6. Place the filter pellets in the net
the bio-surface filters
7. Place the foam filter mat
a way that the foam filter mat covers the net
The outlet
8. Screw the filter cover
6
4
3
A
9. Screw the connection piece
10. Decide on the location for the filter.
5
11. Decide on the length of the pressure hose
charge hose
12. Cut the hose supplied to correspond to the two hose lengths.
2
13. Connect the pressure hose to the connection piece
1
12
0
A
from the filter container
and
3
from outside into the filter
4
on to the connection
5
3
on to the lower connection piece
from inside.
6
from inside on to
3
.
7
into the filter container.
8
and spread the net over
7
.
9
in the filter container in such
8
completely.
6
9
is now above the foam filter mat
.
0
A
on to the filter container
.
2
1
on to the pump
.
B
and the dis-
D
.
2
.
Starting up the filter set :
Filter set up alongside the pond :
1. Place the filter container
C
garden pond.
A
2. Set up the pump
that the pump is completely covered with water.
B
E
3. Connect the pump pressure hose
1
nection
D
4. Connect the discharge hose
(at least 5 cm above the surface of the pond) and route into
the pond.
5. Plug mains plug into a 230 V AC socket.
Warning : The pump will start immediately!
Filter set up in the pond :
1. Connect the pressure hose of the pump
nection
C
B
connection of the filter
A
1
2. Unscrew filter cover
water and does not float.
E
3. Set up the pump
D
in the garden pond so that both are completely covered with
water and screw the filter cover
4. Plug mains plug into a 230 V AC socket.
Warning : The pump will start immediately!
Do not allow the pump to run without water :
Do not allow the pump to run without water because dry-running
leads to an undesirable build up of heat and will destroy the pump.
5. Maintenance
The GARDENA filter is largely maintenance-free. However, it must
be cleaned when necessary.
Cleaning the filter :
1. Unplug the pump.
2. Remove the filter cover
0
3. Remove the foam filter mat
4. Remove the net containing the filter pellets
9
a solution of cooking salt (20 g salt / litre) for approximately
24 hours.
5. Then rinse the net
8
6. Place the bio-surface filter
Do not clean under running water because this will destroy
7
the micro-organisms.
7. Empty the filter container completely and clean under running
water.
8. Reassemble filter in reverse order.
9. Start the filter up again
A
(see 4. Putting into Operation : "Starting up the filter set" ).
We recommend cleaning the filter pellets approximately every
6 months (e.g. in salt water) or replacing them to guarantee that
the filter pellets are still able to work properly.
Please contact GARDENA Service about replacing the filter
pellets.
A
in a stable position alongside the
1
in a stable position in the garden pond so
B
to the upper filter con-
C
(max. 50 cm above the surface of the pond).
D
to the lower filter connection
B
to the upper con-
C
D
of the filter and the discharge hose
to the lower
E
.
0
so that the filter container is filled with
1
A
and filter container
in a stable position
0
on again under water.
0
.
9
and clean it under running water.
8
and place it in
8
with fresh lukewarm water.
7
in clean water.
G
E
13