Gardena GH 2300 Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Césped y jardinería Gardena GH 2300. Gardena GH 2300 10 páginas. Garden shredder

Imprimir página

Replacing the Blades :

Problem

Motor does not start

Motor switches off

Shredder does not draw

shredding material in

Insufficient cutting power,

blockage increasing

If any other faults occur, please contact GARDENA Service.

Always replace blades in pairs and only use the

original GARDENA Blade Set.

The GARDENA Blade Set can be ordered indicating

the type of device from GARDENA Service.

1. Press the red OFF switch

and unplug the mains plug.

2. Turn the knob

anticlockwise

until the housing cover

released.

3. Lift the housing cover

The housing cover is help

up by a rod.

4. Turn the blade disk

both flat-head bolts

be seen through the holes.

5. Loosen both flat-head bolts

one after the other using a Torx insert T30.

Loosening the bolts through the two holes prevents the blade

disk from turning.

6. Turn the blade disk

7. Turn the blades

sides.

8. Reinstall the blades

Possible cause

No mains voltage because

fuse is defective.

Power cable defective.

Housing cover not mounted

properly. Circuit breaker is

active (off).

Blockage protection activated to

constant overload or blockage

at the blades.

Blockage due to too soft

shredding material.

Collection container is over-full

(cutting tool blocked).

Blades are blunt.

Repairs to the electrical component must only be carried

out by GARDENA Service or an authorised specialist

dealer.

until

can

and remove the blades

180 ° or replace the worn blades on both

in the opposite order.

Remedy

v Install new fuse.

v Check power cable /

replace power cable.

Close housing cover

and tighten knob

v After the removing blockage

and waiting until the cooling-

down time has elapsed, the

motor can be restarted.

v Add harder branches.

v Empty the collection

container.

v Rotate blades or install new

blades.