Cosco CEB-TRIM 232D Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Bicicleta estática Cosco CEB-TRIM 232D. Cosco CEB-TRIM 232D 14 páginas. Magnetic upright bike

Imprimir página

1. Operating Instruction

the tension control to the end of "+" side,(Under this circumstance the resistance cable stretch longest.) Put

the cable end of the resistance cable into the spring hook of Tension Control Wire as shown on drawing A

of figure 3. Pull the resistance cable of Tension Control (28) up and force it into the gap of metal bracket of

Tension Control Wire (12) as shown on drawing B of figure 3. Connect the resistance cable with the Tension

Control Wire (12) completed as shown on drawing C of figure 3. If the resistance cable can not fit in the

metal bracket, please adjust the nut below the metal bracket. (See Figure 3)

C. Insert the Handlebar Support (27) to the Main Frame (1) and secure it with four sets of M8X16 Bolts (59)

and Ф8 Are Washer (46). (See Figure 3)

4. Install the Handlebar and Computer

a. Attach the Handlebar (25) onto the Handlebar Support (27)

with two sets of M8*20 Bolts (41) and Ф8 arc Washers (46).

b. Connect the Computer cable (13), Hand pulse wire (54) (If

have) to the wire that comes from the Computer (26). Then fix

the Computer (26) on the top of the Handlebar Support (27).

(See Figure 4)

5. Install the Seat Post

a. Attach the Seat Cushion (20) onto the plate of Seat Post (21) with

Ф8

three sets of Nylon Nuts (45) and

Flat Washers (48). (see Figure

b. Insert the Seat Post (21) into the Bushing (22) and the main Frame

(1). Then adjust the Seat Post (21) to the desired hole for the

appropriate position and tighten the Round Knob (19) after

adjustment.

Note: when adjusting the height of seat post, the maximum

insert depth mark line cannot higher than the edge of bushing.