Gardena 4040 Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Sistema de riego Gardena 4040. Gardena 4040 9 páginas. Accu-motormäher
También para Gardena 4040: (alemán) Instrucciones de uso (10 páginas)
This will prevent the mower
Attention! Cutting cylinder con-
switching off automatically,
tinue to run for a few seconds
and could cause fatal injury.
after the motor is switched off.
6. Information Concerning Correct Mowing
6.1 General Remarks
6.2 Mowing
on the Care of Lawns
Tip : Only cut with a sharp cut-
At the beginning of the grass-
ting cylinder so that the grass
cutting season and with newly
is not bruised and turn yellow.
laid lawns, we recommend you
For a clean cut guide the Cord-
select a relatively high cutting
less Motor Mower at an appro-
height (e.g. 45 mm) then gradually
priate speed in lanes as straight
decrease the cutting height over
as possible.
time. To maintain a well kept lawn
you should set the cutting height
Note : The Cordless Motor Mower
to approximately 20 mm.
can be operated with the Accu
or without as a hand mower.
If possible, mow your lawn once
a week. When you mow your lawn
Warning : The revolving cutting
frequently the short roots of the
cylinder can cause injuries.
grass grow making your lawn
Always maintain the distance
more resistant. Always mow your
between the cutting cylinder
lawn when it is relatively dry.
and user suggested by the
To obtain a clean cut guide the
guide handle.
Accu Cordless Motor Mower in
When working on inclines
lanes as straight as possible at
always stand diagonally to the
a walking pace.
incline in a sturdy, safe stance.
Ensure that the lanes overlap
by a few centimetres so that no
To prevent tripping, take par-
uncut strips are left behind.
ticular care when moving back-
wards and when pulling the
Cut the lawn for the first time in
Cordless Motor Mower.
spring when the grass begins to
grow and the lawn can be walked
For information on how to set
on. If the grass has grown too
the cutting height see section
long first cut it length-wise with
"Setting the Cutting Height".
a high cutting height setting
Blockage Protection
(approx. 45 mm) and then cut
If the mower is blocked by a for-
at right angles with the desired
eign body or if the motor is over-
lower cutting height setting (e.g.
loaded, the motor is automatically
25 mm).
switched off by the blockage pro-
The area of lawn you can mow
tection. Remove the key from the
with one charged accu depends
socket. Remove the foreign body
on the height and thickness of
or the cause for the overload and
the lawn, i.e. the taller and thicker
after a few seconds restart the
the lawn, the smaller the area of
mower.
lawn you can mow with one fully
If the motor switches off although
charged Accu.
there are no foreign bodies in the
cutting tool it is possible that the
cutting height you have selected
is too low. Select a higher cutting
height, e.g. 45 mm and then
select a lower cutting height for
the second cut.
18
G
When working with the Cord-
less Motor Mower the Accu
heats up; this is normal and
does not affect its performance.
Circuit Breaker
If the Cordless Motor Mower is
overloaded over a longer period of
time the motor may become hot.
To protect the motor from over-
heating the circuit breaker switch-
es the motor off. You can switch
the mower on again after approxi-
mately 5 -10 minutes.
Automatic Cut-Off
(discharge protection)
The mower switches off auto-
matically as soon as the capacity
of the Accu has been exhausted
(discharge protection). We re-
commend recharging the battery
straight away.
Key
To prevent switching on the Motor
Mower unintentionally, remove
Q
the key
from the socket.
6.3 Mowing with the Grass
Catcher (optional) (Fig. F)
Only attach the grass
A
catcher when the motor
is switched off and the cutting
tool has stopped moving.
Using the GARDENA grass
catcher saves you having to rake
together the grass cuttings.
To attach the grass catcher:
1. Hook the grass catcher holders
G
H
over the hooks
of the
Cordless Motor Mower and
2. Hook the carrying chain onto
the lower part of the guiding
handle.
Note : The height of the grass
catcher can be adjusted using
the latch-in hook on the chain.
For the best grass-catching
results, push your mower at a
walking pace.
7. Maintenance, Care, Storage
7.1 Maintenance
Never expose the Accu to
Maintenance includes all jobs
direct sunlight while charging.
which keep your Accu Cordless
Never charge the Accu any-
Motor Mower in perfect working
where near acids and easily
order. By regularly checking the
inflammable materials.
unit (firm seating of screw con-
Danger of fire !
nections, cracks, damage) and
replacing defective or worn parts
Note: Do not wait until the Accu is
you can prevent accidents and
completely flat before recharging.
failure.
Charge the Accu in a dry place
Repairs may only be carried
as follows (Fig. G):
out by GARDENA service
1. Open the accu cover
centres or dealers authorised
2. Remove the key
by GARDENA.
socket.
3. Plug the plug
Before cleaning and set-
into the charging socket
A
ting the Motor Mower,
4. Then plug the mains plug
switch off the motor and
of the charger into the mains
Q
remove the key
to prevent
socket.
starting the motor unintention-
5. To resume mowing after charg-
ally.
ing the accu, replace the key in
the socket and close the accu
7.2 The Accu (Fig. E / G)
cover.
Charging the Accu
Important :
Note: Only charge the
A
Protect the charging socket
.
Accu with the charger
against dirt and moisture.
supplied ! Using other charging
If the Accu capacity is so
.
units could lead to damage and
low that the Cordless Motor
injury. Using a charger other
Mower switches off automati-
than the GARDENA charger
cally (discharge protection)
supplied releases GARDENA
then the charging time is
from all liability and warranty
24 hours.
claims.
Warning ! The mower
Charging the Accu directly with
A
cannot be started as long
the GARDENA Charging Cable
as the charger is plugged in !
(Art. No. 4040-00.900.01 –
available from GARDENA
We recommend charging the
Service)
Accu immediately after using
1. Take off the Accu (see
your mower using the supplied
"Changing the Accu").
J
charger
for 24 hours.
2. Put the socket of the charging
Important ! If you do not use
cable into the plug of charger
K
the Accu for a longer period of
.
time it will get its full efficiency
3. Connect the plus pole (+) of
after several charging cycles.
the battery with the red clip
and the minus pole (–) with
If the Accu is completely flat,
the black clip.
e.g. due to too long storage
4. Then plug the mains plug of
without any recharge, it will
the charger into the mains
get its full efficiency again after
socket.
several charging cycles.
5. Loosen all connections in
Attention ! Never charge
reverse after charging.
A
the Accu after having
6. Insert the Accu (see
been heated up by operation
"Changing the Accu").
or sun. Let cool down first.
Care
Important ! If you do not use the
Accu for longer periods of time,
it must be re-charged every
6 months to maintain its full effi-
ciency.
Changing the Accu (Fig. E )
If the Accu capacity is completely
exhausted or if the Accu can no
longer be recharged it must be
exchanged. New Accus are avail-
N
.
able from your GARDENA dealer
Q
from the
or directly from GARDENA Ser-
vice, Art. No. 4040-00.600.20.
K
of the charger
Exchange the Accu as follows:
L
.
1. Switch off the Motor Mower.
M
N
2. Open the accu cover
3. Remove the key from the
socket to prevent starting the
Motor Mower unintentionally.
4. Remove the Accu. Pay atten-
tion to the position of the Accu
in the housing.
5. Pull the receptacle for the tabs
O
P
from the tabs
.
6. Insert the new Accu in the
holder in the correct position
as shown in Fig. E1.
7.
Important ! Pay atten-
A
tion to the + / – markings
and the colour markings of
the receptacle for the tabs.
Push the red tab receptacle
on the tab labelled with a plus
sign (+) and the black tab
receptacle on the tab labelled
with a minus sign (–).
8. Please dispose of the Accu
according to the information in
the chapter entitled "Disposing
of and Recycling Accus".
7.3 The Cordless Motor Mower
Cleaning
To avoid injury to persons
A
and material damage:
Never clean your Cordless
Motor Mower with running
water, in particular with water
under high pressure.
After using the mower clean with
a moist cloth. Spray the cutting
cylinder and lower blade with an
oil of low viscosity (e.g. spray oil).
G
.
19