Makita 197413-5 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 197413-5. Makita 197413-5 13 páginas. Cordless cutter
También para Makita 197413-5: Manual de instrucciones (13 páginas), Manual de instrucciones (12 páginas)

Imprimir página

Adjusting the fastening torque

► 1 . Action mode changing ring 2. Adjusting ring

3. Graduation 4. Arrow

The fastening torque can be adjusted in 20 levels by turning the adjusting ring. Align the graduations with the arrow

on the tool body. You can get the minimum fastening torque at 1 and maximum torque at 20.

Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which

torque level is required for a particular application. The following shows the rough guide of the relationship between

the screw size and graduation.

Graduation

Machine screw

Wood

Soft wood

screw

(e.g. pine)

Hard wood

(e.g. lauan)

ASSEMBLY

CAUTION:

Always be sure that the tool is

switched off and the battery cartridge is removed

before carrying out any work on the tool.

Installing or removing driver bit/drill bit

Optional accessory

► 1 . Sleeve 2. Close 3. Open

Turn the sleeve counterclockwise to open the chuck

jaws. Place the driver bit/drill bit in the chuck as far

as it will go. Turn the sleeve clockwise to tighten the

chuck. To remove the driver bit/drill bit, turn the sleeve

counterclockwise.

–

ɸ3.5 x 22

ɸ4.1x 38

ɸ3.5 x 22

Installing hook

► 1 . Groove 2. Hook 3. Screw

The hook is convenient for temporarily hanging the tool.

This can be installed on either side of the tool. To install

the hook, insert it into a groove in the tool housing on

either side and then secure it with a screw. To remove,

loosen the screw and then take it out.

8 ENGLISH

ɸ4.1x 38

–