Makita 6010SD Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6010SD. Makita 6010SD 14 páginas. 10 mm (3/8")

Holding tool

Hold the tool as shown in the figure.

When drilling a large diameter hole,

the tool frimly with both hands.

hold

Drilling in metal

Punch a small hole in the metal to prevent

the bit from skittering when starting to

drill a hole.

Use cutting lubricant on the bitto facilitate

drilling if necessary.

Pressing down too hard on the tool will not speed up the drilling. In fact, this undue pres-

sure will only serve to damage the tip of your drill bit, decrease your drilling performance

and shorten the service life of the tool.

There

is a tremendous force exerted on the tool/bit at the time of hole break through.

Grip the drill firmly and exert care when the bit begins to break through the material.