Makita 6011D Manual de instrucciones - Página 9
Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6011D. Makita 6011D 13 páginas. Equipped with keyless chuck and electric brake
Imprimir página
When driving wood screws, predrill Pilot
holes to make driving easier and to pre-
vent splitting of the workpiece. See the
chart.
3.5 (9/64')
3.8 (5/32")
4.5 (11164")
4.8 (3/16"1
5.1 (13/64")
5.5 (7/32")
5.8 (15/64"1
Nominal
diameter
of
wood screw
(mm)
3.1 (i/8*)
Drilling operation
Drilling in wood
When drilling in wood, best results are obtained with wood drills equipped with
a
guide
screw. The guide screw makes drilling easier by pulling the bit into the workpiece.
To prevent the bit from slipping when starting a hole, make an indentation with a
centerpunch and hammer
a t
the point to be drilled. Place the point of the bit in the
indentation and start drilling.
Use
a
cutting lubricant when drilling metals. The exceptions are iron and brass which
should be drilled dry.
Drilling in metal
CAUTION :
*Pressing excessively on the
tool
will not speed up the drilling. In fact, this excessive pres-
sure will only serve to damage the tip of your bit, decrease the tool performance and
shorten the service life
of
the tool.
*There is a tremendous force exerted on the tool/bit at the time of hole breakthrough.
Hold the tool firmly and exert care when the bit begins to break through the workpiece.
A stuck bit can be removed simply by setting the reversing switch to reverse rotation in
order to back out. However, the tool may back out abruptly if you do not hold
it
firmly.
Always secure small workpieces in
a vise
or similar hold-down device.
Recommended
size
O f
pilot hole
(mm)
2.0
-
2.2
(5/64"
-
3/32")
2.2
-
2.5
(3/32"
-
3/32")
2.5
-
2 . 8 (3/32"
-
7/64")
2.9- 3.2 (7/64"- 1/8')
3 . 1
-
3.4 (118'
-
9/64")
3.3- 3.6 (118'
-
9/63")
3.7
-
3.9 (9/64"
-
5/32")
4.0
-
4.2 (5/32"
-
11/64")
MA1 NTENANCE
CAUTION
:
Always be sure that the tool is switched off and the battery cartridge
is
removed before
attempting to perform inspection or maintenance.
To
maintain product SAFETY and RELIABILITY, repairs, maintenance or adjustment
should be performed by Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
9