Makita 6018D Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6018D. Makita 6018D 13 páginas. Makita cordless driver drill instruction manual 6017d, 6018d, 6019d
También para Makita 6018D: Manual de instrucciones (17 páginas)
Imprimir página
1
1. Low speed
2. High speed
3. Speed change lever
2
3
1. Pointer
2. Weak
3. Strong
4. Torque adjusting ring
ASSEMBLY
1
1. Tighten
2. Sleeve
3. Ring
Speed change
002092
To change the speed, first switch off the tool and then slide the speed change
2
lever to the "II" side for high speed or "I" side for low speed. Be sure that the
speed change lever is set to the correct position before operation. Use the
right speed for your job.
CAUTION:
•
Always set the speed change lever fully to the correct position. If you
3
operate the tool with the speed change lever positioned halfway between
the "I" side and "II" side, the tool may be damaged.
•
Always make sure that the gear is engaged properly by running the tool
under no load after sliding the speed change lever to the desired speed
position. If you operate the tool with the gear engaged improperly, the
tool may be damaged.
•
Do not use the speed change lever while the tool is running. The tool
may be damaged.
Adjusting the fastening torque
For model 6019D only
002099
The fastening torque can be adjusted in 6 steps by turning the adjusting ring
1
so that its graduations are aligned with the pointer on the tool body. The fas-
tening torque is minimum when the number 1 is aligned with the pointer, and
maximum when the
The clutch will slip at various torque levels when set at the number 1 to 5. The
clutch is designed not to slip at the
Before actual operation, drive a trial screw into your material or a piece of
duplicate material to determine which torque level is required for a particular
4
application.
NOTE:
•
The adjusting ring does not lock when the pointer is positioned only
halfway between the graduations.
•
Do not operate the tool with the adjusting ring set between the number 5
and the
CAUTION:
•
Always be sure that the tool is switched off and the battery cartridge is
removed before carrying out any work on the tool.
Installing or removing driver bit or drill bit
002111
Hold the ring and turn the sleeve counterclockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the
2
sleeve clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve counterclockwise.
When not using the driver bit, keep it in the bit holders. Bits 45 mm long can be
3
kept there.
marking is aligned with the pointer.
marking.
marking. The tool may be damaged.
7