Makita 6073DW Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6073DW. Makita 6073DW 16 páginas. Equipped with electric brake 10 mm (3/8”) with fast charger

Imprimir página

I .

SAVE THESE INSTRUCTIONS

- This manual

Length of Cord (Feet)

AWG Size of Cord

contains important safety and operating instructions for battery charger.

2. Before using battery charger, read all instructions and cautionary markings

on (1) battery charger, (2) battery, and (3) product using battery.

3. CAUTION - To reduce risk of injury, charge only MAKITA Battery 7000.

Other types of batteries may burst causing personal injury and damage.

4. Do not expose charger to rain or snow.

5. Use of an attachment not recommended or sold by the battery charger

manufacturer may result in a risk of fire, electric shock,

injury t o persons.

6. To reduce risk of damage to electric plug and cord, pull by plug rather than

cord when disconnecting charger.

7. Make sure cord is located

that it will not be stepped on, tripped over, or

otherwise subjected to damage

stress.

8. An extension cord should not be used unless absolutely necessary. Use of

improper extension cord could result in a risk of fire and electric shock. If

extension cord must be used, make sure:

a . That pins on plug of extension cord are the same number, size, and shape

b. That extension cord is properly wired and in good electrical condition; and

c. That wire size is at least a s large a s the one specified in the table below.

TABLE 1

RECOMMENDED MINIMUM AWG SIZE FOR

EXTENSION CORDS FOR BATTERY CHARGERS

a s those of plug on charger;

100

150

9. Do not operate charger with damaged cord or plug

replace them im-

mediately.

I O . Do not operate charger if

has received a sharp blow, been dropped, or other-

wise damaged in any way; take it t o a qualified serviceman.

1 1 . Do not disassemble charger

or battery cartridge; take it t o a qualified

serviceman when service or repair is required. Incorrect reassembly may

result in a risk of electric shock or fire.

12. To reduce risk of electric shock, unplug charger from outlet before attempt-

ing any maintenance

cleaning. Turning off controls will not reduce this risk.