Makita 6093D Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6093D. Makita 6093D 17 páginas. Equipped with electric brake 10 mm (3/8") with fast charger
También para Makita 6093D: Manual de instrucciones (16 páginas)
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing or removing drill bit or driver bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing
or
removing the bit.
To install the bit, place it in the chuck as
far as it will go. Tighten the chuck by hand.
Place the chuck key
in
each of the three
holes and tighten clockwise. Be sure
to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
I
Chuck key
Holding tool
Hold the tool as shown in the figure.
When drilling a large diameter hole, hold
the tool firmly with both hands.
7