Makita 6227DW Manual de instrucciones - Página 12
Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6227DW. Makita 6227DW 19 páginas. 9.6 v
i2 v
14.4 v
También para Makita 6227DW: Manual de instrucciones (19 páginas), Manual de instrucciones (19 páginas), Manual de instrucciones (19 páginas)
Imprimir página
OPERATION
Nominal diameter of
m d screw (mml
Screwdriving operation
Place the point of the driver bit in the
screw head and apply pressure to the tool.
Start the tool slowly and then increase the
speed gradually. Release the trigger as
soon as the clutch cuts in.
Recommended size of
pilot hole (mml
NOTE:
*Make sure that the driver bit is inserted straight in the screw head, or the screw and/or
bit may be damaged.
3.1 (l/e")
3.5
(W'I
3.8
15/32")
4.5 (11M'I
4.8
(3/16")
5.1 (13,"')
5.5 (7/32"l
5.8 (7/32"1
6.1 (15M"I
*When driving wood screws, predrill pilot
holes to make driving easier and to pre-
vent splitting of the workpiece. See the
chart.
2.0-
2.2
(5/64"
-
3/32")
2.3
-
2.5 13/32''
-
3/32'?
2.5- 2.8
13/32"
-
7/61',)
2.9
-
3.2 (7B-I"
-
1W'I
3.1
-
3.4 (1W'
-
9/64")
3.3
-
3.6 (1W'
-
9/64")
3.7
-
3.9 (9/4"
-
5/32"]
4.0-4.2 W32"
-
11/64")
4.2-4.4(11/64"- 11/61")
*If the tool is operated continuously until the battery cartridge has discharged, allow the
tool to rest for 15 minutes before proceeding with a fresh battery.
Drilling operation
First, turn the adjusting ring so that the pointer on the tool body points to the
8
marking.
Then proceed as follows.
*Drilling in wood
When drilling in wood, best results are obtained with wood drills equipped with a guide
screw. The guide screw makes drilling easier by pulling the bit into the workpiece.
To
prevent the bit from slipping when starting
a
hole, make an indentation with
a
center-
punch and hammer at the point to be drilled. Place the point of the bit in the indentation
and start drilling.
Use a cutting lubricant when drilling metals. The exceptions are iron and brass which
should be drilled dry.
*Drilling in metal
12