Makita 6228DWE Manual de instrucciones - Página 10
Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6228DWE. Makita 6228DWE 19 páginas. 9.6 v
i2 v
14.4 v
También para Makita 6228DWE: Manual de instrucciones (19 páginas), Manual de instrucciones (19 páginas), Manual de instrucciones (19 páginas)
Imprimir página
Speed change
To
change the speed, first switch off the
tool and then slide the speed change lever
to the "11" side for high speed or "I" side
for low speed. Be sure that the speed
change lever is set to the correct position
before operation. Use the right speed for
your job.
t
Lowspeed
6
Highspeed
Speed change
lever
CAUTION:
*Always set the speed change lever fully to the correct position. If you operate the tool
with the speed change lever positioned half-way between the "I" side and
"11"
side, the
tool may be damaged.
Do not use the speed change lever while the tool is running. The tool may be damaged.
Adjusting the fastening torque
The fastening torque can be adjusted in 17
steps by turning the adjusting ring so that
its graduations are aligned with the pointer
on the tool body. The fastening torque is
minimum when the number 1 is aligned
with the pointer, and maximum when the
B
marking is aligned with the pointer.
The clutch will slip at various torque levels
when set at the number 1 to 16. The clutch
is designed not to slip at the
Before actual operation, drive a trial screw
into your material or a piece of duplicate
material to determine which torque level is required for a particular application.
NOTE:
*Do not operate the tool with the adjusting ring set between the number 16 and the
marking.
8
marking. The tool may be damaged.
10