Makita 6311DW Manual de instrucciones - Página 9
Navegue en línea o descargue pdf Manual de instrucciones para Taladro Makita 6311DW. Makita 6311DW 19 páginas. Cordless driver drill equipped with electric brake
Imprimir página
Installing or removing battery cartridge
0
Always switch off the tool before insertion or removal or the battery cartridge.
.To remove the battery cartridge, pull out
the
set
plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the tool.
.To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
it
into
place. Snap the
set
plate back into place.
Be sure to close the
set
plate fully before
using the tool.
If the cartridge does not slide in easily,
it
is not being inserted correctly.
0
Do not use force when inserting the battery cartridge.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
Battery cartridge
m
Reset button
If
the charging light does not come on, press the reset button (yellow) first, then the start
button (red). If the charging light goes out within 10 seconds even after pressing the
reset button and start button
a
couple of times, the battery cartridge
is
dead. (CAUTION:
Wait for more than 5 seconds after the charging light goes out to press the reset button
again.) Replace
it
with
a
new one. When the charging light goes out after about one our,
you may remove the fully charged battery cartridge.
After charging, unplug the charge from the power source.
CAUTION
:
0
Your new battery cartridge is not charged. You will need to charge
it
before use.
0
When you charge a new battery cartridge or a battery cartridge which has not been used
for
a
long period of time, the charging light may not come on. If this occurs, iust press
the reset button (yellow) first, then the start button (red)
as
described before. Charging
will begin.
0
Do not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also,
a
malfunction of the charger may result possibly causing overheating,
etc.
0
If you try to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert
it
and try to charge
it
once more.
0
When you charge
a
new battery cartridge or
a
battery cargridge which has not been used
for a long period, it may not accept a full charge. This is a normal condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging
it
almost completely a couple of times.
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
6