A&R Power Amplifier SA200 Manual del propietario - Página 4

Navegue en línea o descargue pdf Manual del propietario para Amplificador A&R Power Amplifier SA200. A&R Power Amplifier SA200 14 páginas. Stereo power amplifiers
También para A&R Power Amplifier SA200: Manual del propietario (14 páginas)

Imprimir página

Installing and using your

SA150/SA200

Back Panel Connections

Mains Supply

The SA150 and SA200 are normally set up for use with a nominal 240V 50/60 Hz supply.

They can be modified for 220V or 120V operation by your dealer or the manufacturer. CSA

(North American) models are suitable for 120V supplies only. The correct supply voltage is

marked on the rear panel underneath the AC power supply inlet.

The AC power supply inlet of the SA150 and 5A200 is via a standard IEC chassis mounting

plug. A moulded IEC socket, fitted with 2 metres (6.5 ft) of cable, is supplied to fit the IEC plug

(Note that the IEC plug and socket are a tight fit; before first using the amplifier it is therefore

important to ensure that the socket is pushed home firmly into the amplifier's chassis plug).

The wire end of the cable should be terminated with a 3 pin (earthed) plug, wired according to

the international colour code and fitted with a 10 Amp or 13 Amp fuse. The international colour

code is:

Earth

— green/yellow

Live

— brown

Neutral — blue

Some models may already have a suitable plug fitted as standard.

The SA150 and SA200 also have an anti-surge mains fuse fitted internally. It is recommended

that the supply to each model should be disconnected when the amplifier is not in use.

UNDER NO CIRCUMSTANCES SHOULD THE AMPLIFIER COVER BE REMOVED

UNLESS THE SUPPLY IS DISCONNECTED.

Input Connections

A combination of 5 pin DIN socket and phono connectors is fitted as standard. Certain models

may however only have either DIN or phono sockets fitted. In all cases the panel carrying these

sockets is removable to enable special versions to be supplied, e.g. for "bridged mono"

operation or professional applications. Contact your dealer or the factory for further details.