A'OK AC-135 Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Mando a distancia A'OK AC-135. A'OK AC-135 3 páginas.

Imprimir página

Delete a limit position

a. Wait 30 seconds after last command.

Press the UP and/or DOWN button until

the shade stops at the position to be

deleted. Once it stops, do not change

Delete ALL memory

Program

Button

on motor,

left bracket

Add a new Controller to a Shade

Multiple controllers can be linked to one shade:

• Follow Instruction #1 for "Link the Shade to the Remote Control".

• No need to reset upper and lower positions for the shade

Add a new Shade to a Controller

Multiple shades can be controlled by a single remote:

• Power only the 1

shade of the group of shades. Remove power to other shades on same group.

• Setup 1

shade starting at Instruction #1, and set upper/lower positions.

• Remove power to 1

shade. Power up the next shade, setup this shade starting at Instruction #1, and set upper and lower positions.

• Repeat the process, ensuring that power is off to shades not being programmed. After the last shade is programmed, reapply power to all.

Notes: If action between steps (a, b, c) takes longer than 30 seconds, the program will not complete. Simply start each step again at 'step a.'

Up to 4 intermediate stops can be set by following Step 3 for each

Not sure what Step is next, or Everything is messed up? Go to 'Delete ALL memory' step on this page and start over at Instruction #1.

Leviosa Shades Programming Instructions

(the upper limit cannot be deleted unless all positions are deleted)

position.

(including the remote and limits - resets the motor to factory settings)

With a paper clip or small screwdriver, PRESS the PROGRAM BUTTON on the

motor 4 times in a row – you will hear a beep after each press. Then PRESS/HOLD

the button again for 3 seconds until shade rotates briefly up and down.

 ALL memories are now deleted. Go to Instruction #1 to Link to a Remote

Other actions

b. Use a paperclip

to PRESS/HOLD the

button on the BACK

of the remote for

7 seconds

(page 2)

c. After 1 second, the shade rotates

briefly up and down.

KEEP PRESSING/HOLDING button.

After 5 more seconds, the shade

rotates briefly up and down again.

The position is now deleted.