AEG B3007H-B Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Horno AEG B3007H-B. AEG B3007H-B 39 páginas. 30” built-in oven

B -

Using the appliance for the first time

After installation remove all notification labels (not identification or warning labels) and packaging

materials. After cleaning make sure cleaned surfaces are thoroughly rinsed and wiped dry using a

clean, soft cloth.

NOTE: Oven will not operate unless time clock is set

The clock will require setting when you first turn on the power (or following a power failure). The

time of day is displayed in digital 24-hour format (ie. 18:00 is 6:00 p.m.). The power on the timer

shows the clock flashing and is increased by one unit every minute. The oven does not work until

the time is set.

Burning in

Before cooking in the appliance an initial pre-heating is required to burn off the fine oil film used to

protect the elements for shipping. The first time you heat up the oven (or grill) the oil will be given

off as smoke, which is perfectly normal.

Select a cooking mode and set the oven temperature to 180°C. With the oven door closed, leave

for approximately 5 minutes.

Repeat the above step for each cooking mode.

After completing the above make sure all controls are turned off. The oven is now ready for

cooking and grilling.

NOTE:

On oven start up or possibly at other times, due to electricity supply deviations – the

programmer may freeze on a function – if this occurs we recommend that, after checking

other solutions without success, it is recommended that power supply be disconnected to

the appliance for a few minutes, then reconnect. This may result in clearing the frozen

position, allowing you to reset the clock for normal operation.

The ovens are provided with a cooling fan motor to reduce the heat around the oven. The fan

motor is activated independently from oven temperature.

When you end the cooking program, the cooling fan will continue to operate until the oven

temperature drops below 70°C. This safeguards both the oven and the adjoining cupboards from

the possibility of temperature damage.

Your oven is fitted with an over temperature sensor that will automatically shut down your oven

for a period if it is deemed to be overheating - this sensor is fitted to the rear wall of the oven,

inside the outer case – it will only activate in extreme circumstances and is provided as protection

to the appliance and the adjoining furnishings. If activated it will shut down the appliance for a

short time and will automatically reset allowing normal operation – you should consult your

service technician if the problem re-occurs.