ALISEO ALS-020844-CP Especificación del producto
Navegue en línea o descargue pdf Especificación del producto para Mobiliario interior ALISEO ALS-020844-CP. ALISEO ALS-020844-CP 2 páginas.
Imprimir página
ALISEO GmbH
Leutkirchstraße 63
77723 Gengenbach
Germany
Tel. +49 (0) 7803 - 60279-0
Fax +49 (0) 7803 - 60279-30
E-Mail: [email protected]
www.aliseo.de
Product drawing
Installation tools
Tape measure
6mm drill bit
pencil
Installation steps
1
1. Make sure the power supply is
disconnected before wiring.
2. Only personnel with national
professional qualification electrician
grade certificate are allowed to carry out
electrical installation and commission-
ing;
3. Ground wire, live wire and zero wire
must be connected in strict accordance
with the wiring mode shown in the
figure;
4. First connect the ground wire with the
product ground wire, and then connect
the zero wire and live wire of the
product.
3
As shown in the figure, use
6mm drill bit to drill holes on
the wall surface, and reserve
holes on the right φ 17 power
supply three core wire hole.
5
Take out the mirror lamp from
the packing box and place it
in a flat place. Be careful not
to scratch.
① Take out a 2mm hex wrench
from the accessory box and
loosen the M4 screws on the
wall seat counterclockwise as
shown in the figure;
② Take out the fixing seat and
place the removed screws in a
safe place for standby.
Product specification
Applicable product model：020844
Electric drill
bolt driver
Disconnect the
power supply
25
25
4- φ 6 depth 50mm
Take out the fixing seat
①
②
①
Fixed seat
hex wrench
2mm
Detailed installation drawing
Expansion rubber plug
Fixed seat
Self tapping screw
Accessory box parts
Expansion
Claw hammer
rubber plug x4
2
The position of outlet hole
shall be reserved on the wall,
Drill holes according to the
dimensions given.
4
Take out 4 expansion rubber
plugs from the accessory box.
Insert the expansion rubber
plug into the hole and fully
enter it with a sheep horn
hammer. The expansion
rubber plug cannot be exposed
to the wall.
6
Take out 4 self tapping screws
from the accessory box.
Put 4 screws through the fixing
seat, then install the fixing seat
on the wall with a cross
screwdriver, adjust the direction
of the fixing seat and tighten it.
Self tapping
2mm hex wrench
screw x4
Opening dimension drawing
25
25
Expansion
Input wire: zero wire,
rubber plug
live wire and ground wire.
Install the fixing seat
Self tapping
Input wire: zero wire,
screw
live wire and ground wire.
01