Garmin ZUMO Zumo 400 Manual de instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de instalación para GPS Garmin ZUMO Zumo 400. Garmin ZUMO Zumo 400 46 páginas. Personal motorcycle navigator
También para Garmin ZUMO Zumo 400: Hoja de instalación (2 páginas), Manual de consulta rápida (2 páginas)
Imprimir página
Attaching the Base Plate to the Motorcycle Mount
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
washers
, cradle, spacers
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base
base plate
with the double-socket arm
2
Insert the ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
6
Align the ball of the base plate attached to the cradle
the other end of the double-socket arm.
7
Repeat steps 2–4.
Installing Your Device in the Motorcycle Mount
1
Fit the bottom of your device into the cradle.
2
Tilt the device back until it snaps into place.
NOTICE
through the
, and base plate
.
and the ball of the
.
NOTE: If the latch on top of the mount stays up after you
insert the device, press it down.
Removing Your Device from the Motorcycle
Mount
1
Press the button on the side of the mount.
2
Lift out the device.
3
On the motorcycle mount, place the weather cap on the
power connector in the center of the cable
Power Cables to the Motorcycle
Mounting Your Device in an Automobile
Before mounting the device, check the local laws pertaining to
windshield mounting.
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
1
Pull back the weather cap on the back of the cradle.
2
Plug the automotive power cable
connector
under the weather cap.
3
Remove the clear plastic from the suction cup.
4
Clean and dry your windshield and the suction cup with a lint-
free cloth.
with
5
Press the suction cup
back toward the windshield.
6
Snap the cradle
7
Fit the bottom of your device into the cradle.
8
Tilt the device back until it snaps into place.
TIP: Press on the logo at the top of the device while holding
the tab at the top of the cradle.
9
Plug the other end of the automotive power cable into a
power outlet.
(Attaching the
Mount).
NOTICE
WARNING
into the mini-USB
to the windshield, and flip the lever
onto the suction cup arm.
3