Garmin camper 660 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Sistema de navegación Garmin camper 660. Garmin camper 660 28 páginas.
También para Garmin camper 660: Manual de inicio rápido (21 páginas)

Imprimir página

Getting Started

See the Important Safety and Product Information guide in the

product box for product warnings and other important

information.

• Install the camera memory card

Memory

Card).

• Update the maps and software on your device

Maps and Software with Garmin

• Mount the device in your vehicle and connect it to power

(Mounting and Powering the nüviCam Device in Your

Vehicle).

• Align the dash camera

(Aligning the

• Acquire GPS signals

(Acquiring GPS

• Adjust the volume

(Adjusting the

brightness

(Adjusting the Screen

• Navigate to your destination

Installing the Dash Camera Memory Card

Before the device can record video from the integrated dash

camera, you must install a camera memory card. The camera

requires a microSD

™

or microSDHC memory card up to 64GB

with a speed rating of class 4 or higher. You can use the

included memory card, or you can purchase a compatible

memory card from an electronics supplier.

Insert a memory card

NOTE: If you install the memory card into the incorrect slot,

the camera cannot record video.

Press it in until it clicks.

Mounting and Powering the nüviCam Device

in Your Vehicle

This product contains a lithium-ion battery. To prevent the

possibility of personal injury or product damage caused by

battery exposure to extreme heat, store the device out of direct

sunlight.

Both the device and its mount contain magnets. Under certain

circumstances, magnets may cause interference with some

internal medical devices, including pacemakers and insulin

pumps. Keep the device and its mount away from such medical

devices.

Both the device and its mount contain magnets. Under certain

circumstances, magnets may cause damage to some electronic

devices, including hard drives in laptop computers. Use caution

when the device or its mount is near electronic devices.

Before you use your device on battery power, you should charge

it.

Press the mount

onto the suction cup

place.

Getting Started

WARNING

(Installing the Dash Camera

(Updating

Express).

Camera).

Signals).

Volume) and display

Brightness).

(Starting a

Route).

into the camera memory card slot

WARNING

NOTICE

until it snaps into

Open the lever

, press the suction cup to the windshield,

and flip the lever back toward the windshield.

The lever must be oriented toward the top of the windshield.

Extend the suction cup arm

If necessary, rotate the mount so the Garmin

right-side up.

Plug the vehicle power cable

Place the back of the device onto the mount.

Plug the other end of the vehicle power cable into a power

outlet in your vehicle.

Acquiring GPS Signals

To navigate with your device, you must acquire satellites.

the status bar indicates the satellite signal strength. Acquiring

satellites can take several minutes.

Turn on the device.

Wait while the device locates satellites.

If necessary, go outdoors to an open area, away from tall

buildings and trees.

Status Bar Icons

The status bar is located at the top of the main menu. The status

bar icons display information about features on the device. You

can select some icons to change settings or view additional

information.

GPS signal status

Bluetooth

technology status (appears when Bluetooth is

enabled)

Current time

logo faces

into the port on the mount.