Garmin GMA 1347D Manual de instalación - Página 19

Navegue en línea o descargue pdf Manual de instalación para Pantalla de aviónica Garmin GMA 1347D. Garmin GMA 1347D 47 páginas.

2.3.1.4

Marker Beacon Antenna Cable Installation

This section provides guidance for terminating the coaxial cable into the D-Sub connector. See the

system interconnect section for pin assignments.

Use coaxial cable meeting the applicable aviation regulation for the marker beacon

antenna. Route the cable to the D-Sub as described in Section 2.3.1.3.

When terminating the coaxial cable into the D-Sub observe the following guidance (refer to Figure 2-1):

• Keep the distance from the end of the exposed shield to D-Sub as short as possible.

• Ensure the distance from the beginning of the exposed shield to D-Sub is no more than

1.5 inches long.

• Terminate the center conductor by directly connecting it to the D-sub through a crimp pin

without a pigtail.

Figure 2-1 below represents a suggested method for terminating the marker beacon coaxial cable using

M17/128-RG400 terminated into a 78 Pin high density D-Sub connector. Refer to Table 2-1 for Crimp

Tool, Pin, and Crimp Tool Insert part numbers.

Figure 2-1. GMA Marker Beacon Coaxial Cable D-Sub Termination

CRIMP TOOL

DANIELS MANUFACTURING CORP

DMC M22520/2-01 GAGE

AFM8 CRIMPING TOOL

GMA 1347D Installation Manual

190-00303-21

NOTE

Table 2-1. Pin and Crimp Tool Part Numbers

Garmin Part Number

336-00021-00

336-00044-00

CRIMP TOOL INSERT

K42

K774

Page 2-3

Revision C