AlkaWay UltraStream Manual - Página 5
Navegue en línea o descargue pdf Manual para Sistemas de filtración de agua AlkaWay UltraStream. AlkaWay UltraStream 20 páginas. Benchtop and undersink installation
También para AlkaWay UltraStream: Manual del usuario (6 páginas), Manual del usuario (4 páginas)
Imprimir páginaBenchtop Installation - Part 2
1. REMOVE AERATOR FROM YOUR FAUCET
Most modern mixer taps have a aerator that can
be unscrewed counter-clockwise by hand (make
sure you keep this in a safe place, as often they
are unique to each tap and hard to replace).
2. ATTACH DIVERTER TO FAUCET.
Screw the adaptor ring to the diverter (hand tight).
Then screw the adaptor ring diverter assembly
to the tap (use a little Teflon plumbers' tape if
needed), taking care not to twist the hose.
If you need the hose to be shorter... remove
the hose by Unscrew the knurled collar from the
diverter and pull off the hose from the diverter.
Then cut the hose to the required length. Push the
hose back onto the diverter and re-screw on the
knurled collar tightly.
3. TURN ON WATER
Push the diverter pin to divert flow into your
UltraStream.
4. FLUSH THE NEW FILTER
Run the ultrastream for approximately 5-10 mins
at around 1 litre (0.26 gallons) per minute to
remove filter dust residues and fully soak the filter
media. Do not drink this water.
5. TURNING OFF
When you turn off the flow at your faucet, filtered
water may still flow for 10-20 seconds. This is due
to residual pressure that may build up inside the
UltraStream's highly efficient filter. It will also drip
for some time due to the power of the hydrogen
generation in the filter.
6. ADJUST THE FLOW
Go to page 12
7. TROUBLESHOOTING
Go to page 13
For videos, help and support go to support.alkaway.com
p5