Garmin GPSMAP 2010 Manual de instalación - Página 2

Navegue en línea o descargue pdf Manual de instalación para Sistema GPS marino Garmin GPSMAP 2010. Garmin GPSMAP 2010 8 páginas. Garmin gsd 20 marine-remote sounder: release note
También para Garmin GPSMAP 2010: Manual de instrucciones de instalación (12 páginas), Declaración de conformidad (1 páginas), Declaración de conformidad (1 páginas), Manual del usuario (20 páginas)

GPSMAP 2006 / 2010/ GPS 17N Installation Guide

Introduction

The GPSMAP 2006/2010 must be properly installed according to the follow-

ing instructions to get the best possible performance. To complete the installation,

you'll need the appropriate fasteners, tools and mounts listed in each section. These

items should be available at most marine dealers. When in doubt, seek profes-

sional assistance.

Surface Mount

Tools

Drill

Pencil

Drill Bit

Screw Driver

• Mounting Hardware (Fasteners) Not Included

Installing the Bail Mount and Unit:

1. Using the Bail Mount as a template, mark the location of the four mounting holes

with the pencil. Be sure to leave at least two inches of clearance behind the unit

for the wiring connector.

2. Using an appropriate size drill bit, drill pilot holes for the fasteners that you choose

to use.

3. Secure the Bail Mount to the surface with the fasteners.

4. Loosen the Mounting Knobs.

5. Slide the unit into the Bail Mount and tighten the Mounting Knobs.

Flush Mount

Tools

Jig Saw

Center Punch

Scissors

Masking Tape

Drill Bits

1/16"(2mm) Allen (Hex) Wrench

Drill

Hammer

Sockets or Pliers

Included Mounting Hardware

4 - 3mm Studs

4 - Flat Washers

8 - 3mm Hex Nuts

(continued on next page)

Mounting Knobs

Bail Mount

FlushMount