Garmin GPSMAP 400 series Manual de instrucciones

Navegue en línea o descargue pdf Manual de instrucciones para Sistema GPS marino Garmin GPSMAP 400 series. Garmin GPSMAP 400 series 6 páginas. Non-waas; display interfaces
También para Garmin GPSMAP 400 series: Apéndice del Manual del Piloto (27 páginas), Manual de consulta rápida (2 páginas), Manual de referencia (2 páginas), Manual de instrucciones de instalación (28 páginas), Manual de instrucciones de instalación (30 páginas), Manual de plantillas (2 páginas), Plantilla (1 páginas), Manual de configuración (2 páginas), Manual del piloto (28 páginas), Manual de consulta rápida (2 páginas)

Garmin GPSMAP 400 series Manual de instrucciones
NOTE: These instructions assume the user has experience operating the applicable 400/500 Series Unit and is familiar with the
operation of RAIM. The fi gures in this addendum are derived from the 400/500 Series units. The information in this document
applies to all 400/500 units unless otherwise stated.
FAULT DETECTION AND EXCLUSION (FDE)
The GARMIN 400/500 Series Main and GPS Software version 3.00 and higher (Figure 1) incorporate Fault Detection and
Exclusion (FDE) display interface and control, satisfying the requirements for "GPS as a Primary Means of Navigation for Oceanic/
Remote Operations" per FAA Notice N8110.60.
FDE consists of two distinct parts, fault detection and fault exclusion. The fault detection part detects the presence of an
unacceptably large pseudorange error (and presumably, position error) for a given mode of fl ight. Upon the detection, fault
exclusion follows and excludes the source of the unacceptably large pseudorange error, thereby allowing navigation to return to
normal performance without an interruption in service. To enhance safety, FDE functionality is provided for other phases of fl ight
(non-precision approach, terminal, en route). The FDE functionality for non-oceanic fl ight phases adheres to the same missed alert
probability, false alert probability, and failed exclusion probability specifi ed by N8110.60.
The following 400/500 Series Units are affected:
• GPS 400
• GNC 420/420A
• GNS 430/430A
• GPS 500 (TAWS)
• GNS 530/530A (TAWS)
PRE-DEPARTURE VERIFICATION OF FDE
An FDE prediction must be performed prior to departure for a fl ight plan involving:
• Oceanic/Remote operation where GPS is to be the sole source of navigation per FAA Notice 8110.60
• U.S. Area Navigation (RNAV) routes, Standard Instrument Departures (SIDs), or Standard Terminal Arrival Routes (STARs) if a
NOTAM indicates a GPS satellite (or satellites) is scheduled to be out-of-service, per FAA AC 90-100 "U.S. Terminal and En Route
Area Navigation (RNAV) Operations"
Prior to departure, the operator must use the FDE Prediction Program supplied with the 400/500 Trainer Software to
demonstrate that there are no outages in the capability to navigate on the specifi ed route of fl ight (the FDE Prediction Program
determines whether the GPS constellation is robust enough to provide a navigation solution for the specifi ed route of fl ight).
190-00643-00 REV. A
400/500 SERIES FDE PREDICTION INSTRUCTIONS
Figure 1. Software Version Screen
Page 1