alkitronic EAF Manual de funcionamiento y mantenimiento - Página 7
Navegue en línea o descargue pdf Manual de funcionamiento y mantenimiento para Bomba de agua alkitronic EAF. alkitronic EAF 16 páginas. Battery powered torque multiplier
Imprimir página
4.2
Preparing for work with the power tool
Before preparing the power tool for work remove
the alkitronic® Li-Ion battery pack from the tool.
Depending on the specific job various alkitronic® STACO/
STABI/DMA or special adapters for tightening and loosening
of bolted connections are needed.
• Place the alkitronic® EAF on a flat surface.
• If the DMA (reaction torque absorber) is fitted with a
safety screw, completely remove this screw (the position
of this screw varies between the tool types).
• Push the DMA (9) onto the gear cogs (10).
• Tighten the safety screw completely to secure the DMA.
DMA safety screw
alkitronic® DMA
DMAR safety washer (accessory)
For DMAs without safety lock a safety washer is available as
an accessory. This washer prevents a loosening of the DMA
and can be pushed over the gear cogs and screwed tight.
battery powered torque multiplier
10
9
7
• Push the STACO / STABI (11)/(12) onto the square drive
(bore holes of the adapter and of the square must be
aligned).
• Insert safety pin (13), secure with rubber ring (14) or com-
pletely tighten STABI safety screw (15).
14
5. Electric operation
5.1 Switching on / off
Switching on: Push and hold button (D). The electronic con-
trol system will ensure a soft start.
Switching off: Release button (D).
Note: The noise that will be emitted during starting is due
to the construction of the tool and has no influence on the
function or longevity of the machine.
Never block the rocker switch, this would make
proper operation impossible.
13
11
alkitronic® STACO
15
12
alkitronic® STABI
D